Radio operation with RDS (Radio Data System)
•Press the desired preset button until the radio resumes play after the muting (takes approximately 2 seconds, con- firmed by a beep).
Now the station has been stored.
Note:
Should you tune into a station which has already been stored before on another mem- ory bank, the corresponding preset button and the memory bank will flash briefly in the display.
Automatically storing the strongest stations with Travel- store
You can automatically store the six most powerful FM and AM stations in your cur- rent reception area sorted according to their signal strength. This function is particularly
•Press TU, menu level 2 will appear in the display.
•Press TS briefly.
The six strongest FM or AM stations will be automatically stored on the memory bank T (Travelstore). If it is not possible to receive six stations, the remaining presets will be marked by four dashes. When this process
has been completed, the radio will play the station with the strongest reception (ST 1).
If desired, stations can also be stored man- ually on the Travelstore bank (see “Storing stations”).
Recalling stored stations
You can recall any stored station at the touch of a button.
FM
Recall the stations on the memory bank selected directly:
•by pressing ST1 - ST6.
To select a station on a different bank:
•Press NEXT as often as necessary un- til the desired memory bank appears and then select the station by pressing ST1 - ST6.
AM
You can select the stations stored for the selected bank directly:
•by pressing ST1 - ST6.
To select a station on a different bank:
•Press NEXT as often as necessary un- til the desired memory bank AM or AMT appears and then select the sta- tion by pressing ST1 - ST6.
Scanning stored stations with Preset Scan
You can have all of the stored stations briefly scanned on all bands and in the selected FM memory bank.
Preset Scan cannot be started unless PTY is switched off (“PTY” is not highlighted in the display).
If necessary, switch off PTY on menu level 2. To do so
•press TU and switch off the function by pressing the corresponding key.
To start Preset Scan:
•Press SCA for approx. 1 second.
All of the stored stations on the band se- lected and within reception range will be scanned one after the other. “SCAN” and the station name or frequency will flash al- ternately in the display.