KeyCard theft protection system

	• Remove the first KeyCard and insert	Short Additional Memory
	the new one while “CHANGE” still ap-	(S.A.M.)
	pears in the display.	The second KeyCard available from your
	After the display indicates “READY” or	The second KeyCard available from your
	After the display indicates “READY” or	specialised dealer allows you to read out
	“LEARN KC”,	short information, which will run through the
	• press DSC.	short information, which will run through the
	• press DSC.	display, such as, for example, the phone
	Now you can also use the new KeyCard for	display, such as, for example, the phone
	Now you can also use the new KeyCard for	number of your car dealer or the emergen-
	operating your unit.	cy call number of your automobile associa-
	A maximum of two cards can be used with	tion.
	the set.	The freely selectable text with a maximum
	If you attempt “train” a third one, the access	of 162 characters can be programmed by
	authorisation for the KeyCard not used for	any dealer who has the required equipment
	the “training” process will be deleted auto-	available.
	matically.	Turn On Message (T.O.M.)
	Displaying the radio pass data	Turn On Message (T.O.M.)
	Displaying the radio pass data	The second KeyCard available from your
		The second KeyCard available from your
	You can use the KeyCard supplied with your	specialised dealer also allows you to dis-
	set to display the radio pass data such as	play a special turn-on message each time
	the model name, product number (7 6 ...)	the radio is switched on.
	and serial number.	The freely selectable text with a maximum

Please refer to the section on “DSC pro- of 48 characters can be programmed by any

gramming - READ KC”.	dealer who has the required equipment
	available.
	Each time you turn on your system with the
	second KeyCard, the programmed text will
	appear in the display.

Optical display as theft protec- tion

Flashing light diode ?

When the vehicle is stationary and the Key- Card has been removed, the light diode can be switched to flash for extra anti-theft se- curity.

For this it is necessary that the positive pow- er supply line and the permanent +12 V lead are connected such as described in the in- stallation instructions.

Make sure that the unit is switched off; the operating panel is unlocked; the KeyCard has been removed; “LED ON” has been selected in the DSC mode (factory setting). If necessary, please refer to the section on “DSC programming - LED”.

Switching off the flashing light

The flashing light can be switched off by selecting “LED OFF” in the DSC menu.