Blaupunkt RCM 126 operating instructions Quick reference

Page 4

Quick reference

1Switching on/off with the ON button: Press ON.

When switching the set on with the ON button, the KeyCard has to be insert- ed. The unit will play with the pre- adjusted volume.

Switching on with the ignition being switched off:

To keep on operating the set when the ignition is switched off (KeyCard is in- serted), proceed as follows:

Press ON after the double beep tone. The unit will be turned on.

To avoid that the battery goes flat, the system will be turned off automatically after a playback time of one hour.

To programme the mute volume level, proceed as follows:

Adjust the desired volume.

Press for two seconds until you hear a beep.

Now this volume level is stored as your mute volume.

Extra function

Memory button in the DSC menu.

FRANÇAIS ENGLISH DEUTSCH

Switching on/off with the KeyCard: The set has to be turned on via the ON button.

Note:

Read the information in chapter “Key- Card theft protection system”.

Switching on/off via the ignition:

When connected correspondingly, the set can also be turned on and off via the vehicle ignition.

After the ignition has been switched off, a double beep tone will remind you that you should remove the KeyCard before leaving your vehicle.

2VOL+ / VOL-

To alter the volume.

Each time the set is switched on, it will play with the pre-adjusted volume (VOL FIX).

You may also change the VOL FIX set- ting (see chapter “DSC programming”).

3

For instantly muting the volume.

By pressing the button the volume will be muted immediately. “MUTE” will appear in the display.

The function is cancelled by pressing button or VOL+.

When pressing VOL-, the normal vol- ume will be by one grade lower than the mute volume.

4FM

To select one of the FM memory banks ITALIANO I and II.

To change the memory bank:

Press FM.

“FM I” or “FM II” will appear on the dis-NEDERLANDSplay panel.

5 TS - Travelstore

 

SVENSKA

Store: Press TS until seek tuning

To store the six most powerful stations

 

automatically with Travelstore:

 

starts in the display.

 

 

Recall: Press TS. “T” is indicated in

ESPAÑOL

the display. Then briefly press one of

 

the preset buttons 1-6.

 

 

 

 

 

 

PORTUGUÊS

 

 

29

Image 4
Contents Heidelberg RCM Page Contents Quick reference Extra rocker switch functions Rocker switchAUD J GEO DSC Mode H PTY Display Flashing KeyCard tongueMIX MIX CDMIX MAG MIX OFF@ DIS Extra function GEO AUDImportant notes KeyCard theft protection system Removing the KeyCardReplacing a KeyCard Never pull out the KeyCard directlySwitching off the flashlight Short Additional Memory S.A.MTurn On Message T.O.M Optical indication for extra securityRadio operation with RDS Radio Data System Scrolling through the broad- casting networks Changing the memory bankStoring stations Automatically storing the stronSelecting the seek tuning sensi- tivity Preset ScanSwitching from stereo to mono Recalling stored stationsProgramme type NewsScanning stations with PTY-SCAN Storing programme typesPTY priority Automatic seek tuning start Switching the warning beep offReceiving traffic programme stations with RDS-EON On/offTape operation Switching the tape side Scanning cassette titles with Skipping unrecorded tapePortions with Blank Skip Dolby B NRSwitching to CDC operation CD changer operation optionalCare notes Selecting CDs and titlesSelecting the display mode Storing the display modeMIX playback Entering CD namesDSC programming Deleting CD names withColour Scantime AUXSpecifications Overview of the DSC factory settingsAppendix Blaupunkt-Werke GmbH
Related manuals
Manual 31 pages 21.97 Kb Manual 33 pages 27.68 Kb