DSC programming
You have the choice between the capital letters A to Z, special characters and the numbers 0 to 9.
•Use the rocker switch << >> to move to the next underscore and select a character.
You can select up to seven characters. Once you have completed the name as de- sired:
•Press 
in order to store it. To quit the naming mode,
•leave the DSC menu by pressing DSC. If you would like to name another CD,
•select a new disc.
You can change any existing name by en- tering and storing a new one (overwriting).
Deleting CD names with
DSC-UPDATE
You can delete a CD name with the help of the DSC update function. Use “CDC UPD” to confirm all of the CDs for which the spe- cified name is not to be deleted.
•Insert a magazine with CDs for which the stored information is to be main- tained.
•Press the DSC button.
•Press 
/
to select “CDC UPD”.
•Press << >>.
After the update has been completed, “NEXT MAG” appears in the display.
•Press the 
button on the changer for approximately two seconds.
The magazine will eject.
•Insert the next magazine.
Proceed as described above for all of the CDs/magazines for which the entered name is to be maintained.
•After having updated the last magazi- ne, press 
.
To quit the function,
•press DSC.
The system has saved the name informati- on for all of the CDs which were inserted. For all other discs the CD names have been deleted.
DSC (Direct Software Control) allows you to customise certain programmable, basic settings to suit your personal needs and pre- ferences and then store them.
The basic settings for this audio equipment were made at the factory.
In the following you can find an overview of these settings, so that you can always reset to these if desired.
If you wish to alter any of the programming,
•press DSC.
Use the rocker switch and the 
button to select and adjust the functions described in the following. The display will show you the adjusted condition.
/
Select function
<<>> Adjust/recall value
48