If desired, stations can also be stored manually on the Travelstore bank (see “Storing stations”).
Recalling stored stations
You can recall any stored station by pres-
Selecting the seek tuning sensi- tivity
You can alter the automatic seek tuning sensitivity.
If “lo” is displayed, the radio will only pick up
• Press SC briefly.strong, local stations (low sensitivity).
sing the corresponding preset button.
• Select the waveband using FM or TS. |
The scanned frequency or the station name will start flashing in the display. During the
If “lo” does not light up, the radio will also pick up weaker, distant stations (high sen- sitivity).
• Briefly press the corresponding preset |
button. |
actual scanning process
To select a scanned station and switch
modes (see also chapter “DSC program-
Scanning stored stations with
off the
ming”).
Preset Scan
You can have all of the stored stations briefly scanned on all wavebands.
To start Preset Scan:
•Press SC for approximately two secon- ds.
All of the stored stations of the adjusted
• Press SC briefly.
Switching from stereo to mono
If reception is poor, you may get better sound quality by switching to mono:
• Press the lo button for approximately two seconds.
With mono playback, the stereo sign 
will disappear from the display.
waveband will be scanned one after the
The scan time can be changed from be-
Each time the radio is switched on, stereo
other. The memory bank and preset posi-
tween five to a maximum of 30 seconds.
playback is activated.
tion of the currently scanned station will flash in the display.
To select a scanned station and switch off Preset Scan:
•Press SC briefly.
The unit will automatically switch to mono if Please refer to chapter “DSC programming the received signal is not strong enough for - SCANTIME”.
stereo playback.
40