Scanning stations with Radio- Scan
You can also scan all stations which can currently be received.
To start the Scan function:
•Press SC briefly.
The scanned frequency or the station name will start flashing in the display. During the actual scanning process
To select a scanned station and switch off Radio-Scan:
•Press SC briefly.
If no station is selected, the scan function will be automatically switched off after the frequency band has been run through com- pletely. The unit will tune in the station lis-
To switch the seek tuning sensitivity:
•Press lo briefly.
The sensitivity level can be altered sepa- rately in both modes. Please refer to chap- ter “DSC programming -
Switching from stereo to mono
Every time the radio is switched on, stereo playback is activated automatically.
The unit will gradually switch to mono if re- ception is poor.
You can also switch between mono and ster- eo reception manually:
•Press the lo button for approximately 1 sec.
The selected condition will briefly appear in the display.
PTY – Programme-Type
PTY is an RDS service offered by more and more radio broadcasters. This feature allows you to select FM stations according to their programme type. After you have chosen the PTY of your preference, the corresponding stations can be selected either by seek tun- ing or using the scan function.
Switching PTY on/off
•Press PTY.
When the function is active, the programme type selected last will briefly appear in the display. “PTY” will be permanently indicat- ed in the lower right corner of the display panel.
tened to before starting the scan.
Selecting the seek tuning sensi- tivity
You can alter the automatic seek tuning sensitivity.
If “lo” is displayed, the radio will only pick up strong, local stations.
If “lo” does not light up, the radio will also pick up weaker, distant stations.
Loudness
Adjusts the low bass frequencies for a more natural sound.
Switching Loudness on/off:
•Press the AUD button for approximate- ly 1 sec.
When the Loudness function is active, “LD” will light up in the display.
See chapter “DSC programming” for more information.
Programme type
Use << >> to have the last selected pro- gramme type displayed and to choose a new one.
You can select any one of the stored types with the preset buttons
Condition: PTY must be active.
Using DSC you can choose between Ger- man and English (see “DSC programming - PTY LANG”).
All of the programme types listed below are available.
34