JVC KD-R514 Line output, Mode An external amplifier, Frequency, Keytouch tone, Amplifier gain

Category

AUDIO

SRC SELECT

Menu item	Selectable setting, [Initial: Underlined]
L/O MODE	• SUB.W	: Select if the REAR LINE OUT terminals are
Line output		used for connecting a subwoofer (through
mode		an external amplifier).
	• REAR	: Select if the REAR LINE OUT terminals are
		used for connecting the speakers (through
		an external amplifier).
SUB.W FREQ *5	• LOW	: Frequencies lower than 72 Hz are sent to the
Subwoofer cutoff		subwoofer.
frequency	• MID	: Frequencies lower than 111 Hz are sent to
		the subwoofer.
	• HIGH	: Frequencies lower than 157 Hz are sent to
		the subwoofer.
SUB.W LEVEL *5	SUB.W 00 —	: Adjust the subwoofer output level.
Subwoofer level	SUB.W 08
	[SUB.W 04]
BEEP	• BEEP ON	: Activates the keypress tone.
Keytouch tone	• BEEP OFF	: Deactivates the keypress tone.
AMP GAIN *6	• LOW POWER	: VOLUME 00 – VOLUME 30 (Select if the
Amplifier gain		maximum power of each speaker is less than
control		50 W to prevent damaging the speakers.)
	• HIGH POWER	: VOLUME 00 – VOLUME 50
AM *7	• AM ON	: Enable “AM” in source selection.
AM station	• AM OFF	: Disable “AM” in source selection.
AUX IN *8	• AUX ON	: Enable “AUX IN” in source selection.
Auxiliary input	• AUX OFF	: Disable “AUX IN” in source selection.

*5	Displayed only when <L/O MODE> is set to <SUB.W>.
*6	The volume level automatically changes to “VOLUME 30” if you change to <LOW POWER> with the
	volume level set higher than “VOLUME 30.”
*7	Displayed only when any source other than “AM” is selected.
*8	Displayed only when any source other than “AUX IN“ is selected.

ENGLISH

15