JVC KD-R711 Back in the order you have, Intended, USB device USB device again Unit cannot detect

34

			Symptom		Remedy/Cause
	Tracks/folders are not played			The playback order is determined by the file name.
	back in the order you have			Folders with numbers on the initial of their names
	intended.			are sorted in numerical order. However, folders with
				no numbers on the initial of their names are sorted
playback				according to the file system of the USB device.
		appears.		iPhone is compatible with this unit.
device	• “READ FAILED” or “NO USB”			• Check whether the connected USB device or the iPod/
		USB device.		the USB device again.
	• The unit cannot detect the			• The USB device is not connected properly. Connect
USB
	While playing a track, sound is			The tracks have not been properly copied into the USB
	sometimes interrupted.			device. Copy tracks again into the USB device, and try
				again.
	Correct characters are not			This unit can only display letters (upper case), numbers,
	displayed (e.g. album name).			and a limited number of symbols.
	The unit does not detect the			• Search from the Bluetooth device again.
	Bluetooth device.			• Reset the unit, then search from the Bluetooth device
				again.
	The unit does not make pairing			Enter the same PIN code for both the unit and target
	with the Bluetooth device.			device.
	Echo or noise occurs.			Adjust the microphone unit’s position.
	Phone sound quality is poor.			• Reduce the distance between the unit and the
				Bluetooth mobile phone.
				• Move the car to a place where you can get a better
				signal reception.
Bluetooth
	phonebook to the unit.			You may have tried to copy the same entries (as stored)
	The unit does not response
	when you tried to copy the			to the unit. Press DISP or T/P BACK to exit.
	The sound is interrupted or			• Reduce the distance between the unit and the
	skipped during playback of a			Bluetooth audio player.
	Bluetooth audio player.			• Disconnect the device connected for Bluetooth
				Phone.
				• Turn off, then turn on the unit.
				• Connect the player again, when the sound is not yet
				restored.
	The connected audio player			• Check whether the connected audio player supports
	cannot be controlled.			AVRCP (Audio/Video Remote Control Profile).
				(Operations depend on the connected audio player.)
				• Disconnect and connect the Bluetooth player again.

ENGLISH

EN30-37_KD-R711_003A_5.indd 34

12/17/09 5:24:14 PM