JVC KD-R711 Fader *7, Balance *8, Loud Loud on, Loud OFF, VOL Adjust, VOL ADJ +05, Mode SUB.W

26

Category				Menu item		Selectable setting, [Initial: Underlined]
			FADER *7		R06 – F06		: Adjust the front and rear speaker output
					[ 00 ]			balance.
			BALANCE *8		L06 – R06		: Adjust the left and right speaker output
					[ 00 ]			balance.
			LOUD		• LOUD ON		: Boost low and high frequencies to produce a
			Loudness					well-balanced sound at a low volume level.
					• LOUD OFF		: Cancels.
			VOL ADJUST		VOL ADJ –05 —		: Preset the volume adjustment level of
			Volume adjust		VOL ADJ +05			each source (except FM), compared to the
					[ VOL ADJ 00 ]			FM volume level. The volume level will
								automatically increase or decrease when you
								change the source.
								• Before making an adjustment, select the
								source you want to adjust.
								• “VOL ADJ FIX” appears on the display if “FM”
								is selected as the source.
		AUDIO	L/O MODE		• SUB.W		: Select if the REAR LINE OUT terminals are
			Line output					used for connecting a subwoofer (through an
			mode		• REAR			external amplifier).
							: Select if the REAR LINE OUT terminals are
								used for connecting the speakers (through an
								external amplifier).
			SUB.W FREQ *9		• LOW		: Frequencies lower than 72 Hz are sent to the
			Subwoofer					subwoofer.
			cutoff frequency		• MID		: Frequencies lower than 111 Hz are sent to the
								subwoofer.
					• HIGH		: Frequencies lower than 157 Hz are sent to the
								subwoofer.
			SUB.W LEVEL *9		SUB.W 00 —		: Adjust the subwoofer output level.
			Subwoofer level		SUB.W 08			[ SUB.W 04 ]
			BEEP		• BEEP ON		: Activates the keypress tone.
			Keytouch tone		• BEEP OFF		: Deactivates the keypress tone.
			AMP GAIN *10		• LOW POWER		: VOLUME 00 — VOLUME 30 (Select if the
								maximum power of each speaker is less than
								50 W to prevent damaging the speakers.)
					• HIGH POWER		: VOLUME 00 — VOLUME 50
*7	If you are using a two-speaker system, set the fader level to “00.”
*8	This adjustment will not affect the subwoofer output.
*9	Displayed only when <L/O MODE> is set to <SUB.W>.

*10 The volume level automatically changes to “VOLUME 30” if you change to <LOW POWER> with the volume level is set higher than “VOLUME 30.”

ENGLISH

EN22-29_KD-R711_003A_5.indd 26

12/17/09 5:23:35 PM