Alpine CDA-7893, CDA-7894, CDA-7892 owner manual Basic Operation

Page 7

Basic Operation

POWER RESET

ANGLE 89

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first time, after installing the CD changer, etc., or after changing the car battery.

1 Make sure that the power of the unit is off. If the power is on, press and hold the POWER button for at least 3 seconds to turn off the unit.

2 Press the RESET switch with a ballpoint pen, or any other pointed object.

Detaching the Front Panel

1 Press and hold the POWER button for more than 3 seconds to turn off the power.

2 Press the (Release) button at upper left side until the front panel pops out.

3 Grasp the left side of the front panel and pull it out.

NOTES

•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction.

•To protect the front panel, place it in the supplied carrying case.

Attaching the Front Panel

1 First, insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.

2 Push the left side of the front panel until it locks firmly into the main unit.

2

1

NOTES

•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.

•Attaching the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake.

Turning Power On and Off

1 Press the POWER button to turn on the unit.

NOTE

The unit can be turned on by pressing any other button except the eject c and CLK/TITLE button.

The volume level gradually increases to the previous level you were listening to before the unit was turned off. Press and hold the POWER button for at least 3 seconds to turn off the unit.

NOTE

The first time power is turned on, the volume will start from level 12.

Display Angle Adjustment

Movable display

The movable display may be adjusted to 3 different angles depending upon user preference.

1 Press the ANGLE 89 button to adjust the angle of the movable display.

NOTES

•The display will close a half minute after the ignition key is turned to the OFF position.

•The adjusted angle of the display is stored in memory. There is no need to re-adjust the angle when the power is turned back on.

CAUTION

Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch.

5-EN

Page 6 Page 8
Image 7
Page 6 Page 8
Contents CDA-7995/CDA-7894 Alpine CD Changers Give You More Contents Information Remote Control OperationMP3 Operation XM Radio OperationPrecautions Never Attempt the Following Basic Operation Audio Mute Function Setting TimeDisplaying Time Setting the Treble Control Setting the Bass ControlAdjusting the built-in Crossover Example 1. Listening Position Front Left Seat About the Time CorrectionExample 2. Listening Position All Seats Bass Focus Example of Steps 2 and 3 SettingTime Difference Table Setting the MX ModeCDA-7995/CDA-7894 only Blackout Mode On and OffQuick Searching Function Changing the Audio Level Display PatternAbout Title and Text Displaying the Title/TextErasing Disc Title/Station Title Titling Discs/StationsDimmer Control Setup OperationSwitching the Tuner Mode Changing Lighting ColorSound Beep Guide Function Turning Mute Mode On/OffScroll Setting Setting the AUX Mode V-LinkSetting the Defeat of the External Input Connecting to an External AmplifierCDA-7894/CDA-7893/CDA-7892 only Demonstration Adjusting Display ContrastCDA-7995 only Radio Operation Manual TuningAutomatic Seek Tuning Manual Storing of Station PresetsTuning to Preset Stations Automatic Memory of Station PresetsOpening and Closing the Movable display CD Player OperationPlayback Fast Forward and Backward Music Sensor SkipRepeat Play Controlling CD Changer Optional When a 12-disc CD Changer is connectedX. Random Play Scanning ProgramsMulti-Changer Selection Playing MP3 Files MP3 OperationPlaying MP3 Files with the CD Changer Optional File Search Selecting FoldersAbout MP3 Setting the Range of MP3 File SelectionWhat is MP3? Playing MP3 DataTerminology Receiving XM Channels with the XM Receiver Optional XM Radio OperationChecking the XM Radio ID Number Changing the Display Storing XM Channel PresetsReceiving Stored XM Channels Category SearchControls on Remote Control Remote Control OperationBattery Replacement Case of Difficulty InformationNo Magzine Antenna FM Tuner Section SpecificationsPrecautions Installation and ConnectionsRemoval Installation38-EN ConnectionsTo prevent external noise from entering the audio system Antenna Receptacle Power Antenna Lead BluePage ALPINE-1 Limited Warranty
Top Page Image Contents