Basic Operation
SOURCE/POWER
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after installing the CD changer, etc., or after changing the car battery.
To do this, first, remove the detachable front panel. Behind the front panel, to the right of the connector, there is a small hole. Using a
Detaching the Front Panel
1 Press and hold the SOURCE/POWER button for more than 3 seconds to turn off the power.
2 Press the 
(Release) button at upper left side until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
NOTES
•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction.
•To protect the front panel, place it in the supplied carrying case.
1
RESET switch
Turning Power On and Off
1 Press the SOURCE/POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except the eject c and DISP/TITLE 
button.
The volume level gradually increases to the previous level you were listening to before the unit was turned off. Press and hold the SOURCE/POWER button for at least 3 seconds to turn off the unit.
NOTE
The first time power is turned on, the volume will start from level 12.
Attaching the Front Panel
1 First, insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
2 |
1 |
NOTES
•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
•Attaching the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake.