Installation
Caution
Do not block the unit’s fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Air ventilation hole
Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the
1
<Rear side>
Mounting Sleeve (Included)
3
Lock Pin
Slide the
No Pressure Here | Dashboard |
|
No Pressure Here
Remove the Detachable Front Panel (refer to page 5). Slide mounting sleeve from main unit. (see “Removal” on this page).
Slide the mounting sleeve into the dashboard.
NOTE
Please examine the installation. Make certain that no external pressure is applied to either the top of the unit or the removable nosepiece.
2 | Screw |
Hex Nut (M5) |
|
| ∗∗ |
| Bolt Stud |
Metal |
|
Mounting |
|
Strap | ∗ |
| |
Ground Lead | |
| Chassis |
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.
NOTE
For the screw marked **, use an appropriate screw for the chosen mounting location.
seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.
Removal
1Remove the DETACHABLE FRONT PANEL.
2Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not
3Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
Screws (M5 ⋅ 8)
Ground Lead
∗ 
Mounting Bracket
NOTE
Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.