Sun Microsystems CP3250 manual Installing a DDR2 Dimm

2.3.6.2Installing a DDR2 DIMM

The following procedure provides a general guide for installing additional memory. However, for specific directions on installing DIMMs on the Sun Netra CP3250 blade server, refer to the documentation that shipped with the DIMMs.

1. Access the blade server by performing one of the following procedures:

■If the Sun Netra CP3250 blade server is installed in an ATCA shelf, remove the blade server from the shelf as explained in Section 2.3.3, “Removing the Netra CP3250 Blade Server” on page 2-18.

■Remove the Sun Netra CP3250 blade server from its antistatic envelope and place it on an ESD mat near the ATCA shelf.

2. Take antistatic precautions: Attach and electrically ground the wrist strap.

Caution – Always wear a grounded antistatic wrist strap when handling DIMMs.

3.Locate the DIMM connectors on the Sun Netra CP3250 blade server.

Select the connectors where you will install the DIMM. See FIGURE 2-5for DIMM slot locations.

Caution – Do not remove the DIMM from its antistatic container until you are ready to install the DIMM on the Sun Netra CP3250 blade server. Handle the DIMM only by its edges. Do not touch DIMM components or metal parts. Always wear a grounded antistatic wrist strap when handling DIMM.

4.Remove the DIMM from its protective packaging, holding the module only by the edges.

Note – Before installing a replacement DIMM, verify that the new DIMM is the same size as its paired DIMM.

5.Holding the DIMM upright to the blade server, insert the bottom edge of the DIMM into the bottom of the slot’s hinge-style connector (FIGURE 2-6).

Caution – Evenly engage the DIMM in its hinge-style slot; uneven contact can cause shorts that will damage the Sun Netra CP3250 blade server. Do not rock the DIMM into place. Ensure that all contacts engage at the same time. You will feel or hear a click when the DIMM properly seats in the connector.

Chapter 2 Hardware Installation and Service 2-21