INSTALLING THE WATER

DISPENSER LINE

A water dispenser with a filter is one of the helpful features on your new refrigerator.

To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that.

In order for the ice maker to operate properly, a water pressure of 138 ~ 862 kPa is required.

Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in about 10 seconds.

If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure. After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled.

To do this, press the water dispenser lever until the water runs from the water outlet.

•Water line installation kits are include with unit. You can find it in freezer drawer.

•The new hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused.

Connecting to the water supply line

1.First, shut off the main water supply line.

2.Locate the nearest cold, drinking water line.

3.Follow the Water line Installation Instructions in the installation kit.

CAUTION

The water line must be connected to the cold water pipe.

If it is connected to the hot water pipe, it may cause the purifier to malfunction.

Close Main

Water pipe

Close Main

No gap

Water pipe

 

Parts for water line Installation

Water line fixer and screws

Pipe connector

Water line

4.After connecting the water supply to the water filter, turn your main water supply back on and dispense about 3 L to clear and prime the water filter.

English - 24

DA68-03055C-01.indb 24

2015. 10. 6. �� 11:01