Samsung RF28HMELBSR/ML manual Reverse Osmosis Water Supply

Removing any residual matter inside the water supply line after installing the water filter.

1.Turn ON the main water supply.

2.Run water through the dispenser until the water runs clear (approx. 6 to 7 minutes).

This will clean the water supply system and remove air from the lines.

3.Additional flushing may be required in some households.

4.Open the Refrigerator door and make sure there are no water leaks coming from the water filter.

Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser. If water drips from the dispenser, it means that there is still air in the line.

Reverse Osmosis Water Supply

IMPORTANT : The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 125 psi (241 and 862 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)

If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):

•Check to see whether the sediment filter in the reverse osmosis system is blocked.

Replace the filter if necessary.

•Allow the storage tank on the reverse osmosis system to refill after heavy usage.

•If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter.

If you have questions about your water pressure, call a licensed, qualified plumber.

English - 100

DA68-03055C-01.indb 100 2015. 10. 6.

�� 11:02