Alpine CDA-9807 4-EN, Precautions, Never Attempt the Following, Correct Handling, Inserting Discs

Page 6
Never Attempt the Following

Correct Handling WARNING

Inserting Discs PRECAUTIONS

Never Attempt the Following

Do not grip or pull out the disc while it is being pulled back into the player by the automatic reloading mechanism.

Do not attempt to insert a disc into the unit when the unit power is off.

Correct Handling

Do not drop the disc while handling. Hold the disc so you will not leave fingerprints on the surface. Do not affix tape, paper, or gummed labels to the disc. Do not write on the disc.

CORRECT

INCORRECTCORRECT

Inserting Discs

Your player accepts only one disc at a time for playback. Do not attempt to load more than one disc.

Make sure the label side is facing up when you insert the disc. Your player will automatically eject any disc that is inserted incorrectly. If the player continues to eject a correctly inserted disc, push the RESET switch with a pointed object such as a ballpoint pen.

Playing a disc while driving on a very bumpy road may result in skips, but this will not scratch the disc or damage the player.

New Discs

As a protective measure to prevent the CD from jamming, the CD player will automatically eject discs with irregular surfaces or inserted incorrectly. When a new disc is inserted into the player and ejected after initial loading, using your finger, feel around the inside of the centre hole and outside edge of the disc. If you feel any small bumps or irregularities, this could inhibit proper loading of the disc. To remove the bumps, rub the inside edge of the hole and outside edge of the disc with a ballpoint pen or other such instrument, then insert the disc again.

Center Hole

Center Hole

New

 

 

Disc

Bumps

 

Outside

 

 

(Bumps)

Irregular Shaped Discs

Be sure to use round shape discs only for this unit and never use any special shape discs.

Use of special shape discs may cause damage to the mechanism.

Installation Location

Make sure the CDA-9807/CDA-9805 will not be installed in a location subjected to:

Direct sun and heat

High humidity and water

Excessive dust

Excessive vibrations

Disc Cleaning

Fingerprints, dust, or soil on the surface of the disc could cause the CD player to skip. For routine cleaning, wipe the playing surface with a clean, soft cloth from the centre of the disc to the outer edge. If the surface is heavily soiled, dampen a clean, soft cloth in a solution of mild neutral detergent before cleaning the disc.

Disc Accessories

There are various accessories available on the market for protecting the disc surface and improving sound quality. However, most of them will influence the thickness and/or diameter of the disc. Using such accessories can cause the disc to be out of standard specifications and may create operational problems. We recommend not using these accessories on discs played in Alpine CD players.

Transparent Sheet

Disc Stabilizer

4-EN

Image 6
Contents CDA-9805 Please read before using this equipmentCDA-9807 FM/AM CD Receiver¡Los cambiadores Alpine de CD le ofrecen más Alpine CD Changers Give You MoreChangeurs de CD Alpine vous avez le choix CHA-S634Radio Operation SETUP OperationOperating Instructions CD Player OperationLIMITED WARRANTY Installation and ConnectionsRemote Control Operation XM Radio Operation OptionalPRECAUTIONS 3-ENInstallation Location 4-ENPRECAUTIONS Disc CleaningInitial System Start-Up Turning Power On and OffBasic Operation Detaching the Front PanelLeft and Right/Fader Between Front Adjusting Volume/Balance BetweenSetting Time and Rear/DefeatSetting the Bass Type Setting the Bass ControlSetting the Treble Control 7-EN8-EN Setting the MX ModeBlackout Mode On and Off Basic OperationDisplaying the Title/Text 9-EN10-EN Titling Discs/StationsErasing Disc Title/Station Title Basic OperationSubwoofer On and Off SETUP OperationScroll Setting 11-ENMode Setting the External Input DefeatSetting the AUX Mode V-Link Turning Mute Mode On/OffConnecting to an External Amplifier 13-ENManual Storing of Station Presets Manual TuningAutomatic Seek Tuning Radio OperationStation Title Search Function Automatic Memory of Station PresetsTuning to Preset Stations Quick Search FunctionNormal Play and Pause CD Player OperationInserting/Ejecting Disc 16-ENRepeat Play Music Sensor SkipFast Forward and Backward M.I.X. Random PlayControlling CD Changer Optional Scanning ProgramsTrack Search Function 18-ENMulti-ChangerSelection 19-ENCDA-9807only Playing MP3/WMA FilesPlaying MP3 Files with the CD Changer Optional 20-ENPlaying MP3 Data Scanning filesFolder/File Search Function 21-ENChecking the XM Radio ID Number Storing XM Channel PresetsXM Radio Operation Optional Receiving Stored XM ChannelsChannel/Category Search Function Setting the tuning methodSetting the Auxiliary Data Field Display Changing the DisplayTelephone Mode ON/OFF MobileHub Link OperationOptionalAbout MobileHub Link Incoming Calls25-EN SMS Short Message Service OperationCalling Calling by using the Speed DialRemote Control Operation Controls on Remote Control CDA-9807only26-EN Battery Replacement CDA-9807only 27-ENInformation About MP3/WMA28-EN Terminology 29-ENInformation In Case of Difficulty30-EN BasicERROR ERRORERROR HI TEMPANTENNA 32-ENInformation UPDATINGSpecifications 33-ENInstallation and Connections Precautions34-EN Installation 35-ENConnections 36-ENInstallation and Connections 37-EN Page LIMITED WARRANTY