Paragon CECT P800 ƒ Battery Usage, ƒ Battery Level indicator, ƒ Charging and discharging

Paragon Wireless dual mode mobile phone user’s manual Page 7

Attention:

To save music files onto the Mini SD card you need a card reader connected to a personal computer. For specific information, please contact your local product provider. Vigorous shaking of the mobile phone may dislodge the Mini SD card, resulting in damage or loss.

Please be careful not to lose the Mini SD card, bend it or scratch it. Please avoid putting the Mini SD card in close contact with static charge, dust or water.

1.3.3Battery

This phone is powered by a rechargeable battery. At least one battery pack is included with your purchase. Although initial battery charge may power ON your newly purchased phone, please note that it is very important to fully charge your batter before first use. New batteries should be charged for at least 12-14 hours. Additionally, only recharge your battery when it is empty to maximize battery life.

After three successive charge and discharge cycles the new battery will be in its best working condition. The battery can be charged and discharged for hundreds of times before it ceases to be effective. When the operating time for the battery shortens significantly, replace it with a new battery.

When a battery is fully charged without use, it will begin to discharge automatically after a period of time. For optimum life cycle and operation, only use the charger and battery approved by the mobile phone manufacturer. When the charger is not in use, unplug the power supply. Short-circuiting the battery will cause damage. Exposing the battery to very hot or very cold temperatures will shorten its life. Do not expose the battery to an open flame. To protect the environment, please recycle the battery and do not dispose of it in the garbage.

ƒBattery Usage

The phone standby time and talk time in the specification are based on the ideal working environment. The battery life changes with network conditions, working environment and standard usage.

ƒBattery Level indicator

When the phone display is ON, the battery status is shown on the upper right corner of the screen. A four level indicator shows the amount of charge remaining in your battery.

ƒRemoving and inserting the battery

To remove the battery, shift the lock on the top of the back cover to the right. To install the the battery, place its bottom portion into the socket first, then push down until it’s securely locked in.

ƒCharging and discharging

♦Insert the charger plug into the jack at the bottom of the phone.

♦Plug in the power supply for the charger. An icon will be displayed on the screen indicating that charging is in progress.

♦When charging is complete, the charging icon will stop blinking to indicate that the phone has been charged successfully. It is normal for the battery, phone and charger to become warm while charging.

♦After you have charged the phone, disconnect the power supply and unplug the charger.

♦To ensure proper charge, disconnect the charger from the phone to change or load a battery, then reconnect the charger and phone.