WAP
Receive Mode | [1.6.2] |
Sets up Push Message receiving.
-Accept All: Receives all Push messages.
-Accept None: Rejects all Push messages.
Go to URL | [1.7] |
Allows you to directly input and connect to the desired URL.
Profiles | [1.8] |
NOTE: The parameter settings are already entered as required by the service provider. Care should be taken when you make any modification to a profile since it may cause WAP to be inoperative.
Selects or edits the Connection Profile supplied by the phone.
Select the Profile List and press the [o] key for setup. The Unedited Profile will not be selected.
Select the Profile List and press the [Edit] Soft key to edit a profile.
-Profile Name: Pressing the [o] key allows you to enter the edit mode to change a profile name.
-Home URL: Pressing the [o] key allows you to enter the edit mode to edit the Homepage URL provided by the service provider.
-Connection Type: Select either WAP or HTTP.
-GSM Settings: This menu allows you to set the GSM network proxy, and has the following
WAP
-Gateway/Proxy: If you set the Connection Type for WAP,
Gateway appears. If you set it for HTTP, Proxy appears. Pressing the [o] key allows you to access the
-Data Call Type: Use the left or right navigation key to select
from the two modes: ISDN and Analogue.
-Dial Number: Pressing the [o] key allows you to enter the edit mode to change this item.
-Login ID: Pressing the [o] key allows you to enter the edit mode to change this item.
-Password: Pressing the [o] key allows you to enter the edit mode to change this item.
-GPRS Settings: This menu allows you to set the GPRS network proxy, and it has the following
-Gateway/Proxy: If you set the Connection Type for WAP,
Gateway appears. If you set it for HTTP, Proxy appears. Pressing the [o] key allows you to access the
-APN: It stands for Access Point Name. Pressing the [o] key lets you enter the edit mode to change this item.
-Login ID: Pressing the [o] key lets you enter the edit mode to change this item.
-Password: Pressing the [o] key lets you enter edit mode to change this item.
-DNS Settings: Enter the IP address for the Domain Name Server. You may enter primary and secondary DNS. This function is available only when you are connected to HTTP.
-Bearer: This lets you select the bearer type for each type of network access. Using the left or right navigation key allows you to select from the two modes: GSM Only and GPRS Only.
-Reset Profile: Pressing the [o] key initializes the parameter settings of a profile. You can select from Yes/No.
128 | 129 |