Weslo WCTL35090 user manual Solution, If the walking belt has shifted to the left

PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION:	a.	If the walking belt has shifted to the left		, first		a
		remove the key and	UNPLUG THE POWER CORD		.
		Using the allen wrench, turn the left rear roller adjust-
		ment bolt clockwise, and the right bolt counterclock-
		wise, 1/4 of a turn each. Be careful not to overtighten
		the walking belt. Plug in the power cord, insert the
		key and run the treadmill for a few minutes. Repeat
		until the walking belt is centered.
	b.	If the walking belt has shifted to the right		, first		b
		remove the key and	UNPLUG THE POWER CORD		.
		Using the allen wrench, turn the left rear roller
		adjustment bolt counterclockwise, and the right bolt
		clockwise, 1/4 of a turn each. Be careful not to over-
		tighten the walking belt. Plug in the power cord,
		insert the key and run the treadmill for a few min-
		utes. Repeat until the walking belt is centered.
	c.	If the walking belt slips when walked on		, first		c
		remove the key and	UNPLUG THE POWER CORD		.
		Using the allen wrench, turn both rear roller adjust-
		ment bolts clockwise, 1/4 of a turn. When the walking
		belt is correctly tightened, you should be able to lift
		each side of the walking belt 2 to 3 inches off the
		walking platform. Be careful to keep the walking belt
		centered. Plug in the power cord, insert the key and
		run the treadmill for a few minutes. Repeat until the
		walking belt is properly tightened.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a CUL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be permanently damaged. Remove the key and

UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjustment bolts coun- terclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each

side of the walking belt 2 to 3 inches off the walking platform. Be careful to keep the walking belt cen- tered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

2”–3”

Rear Roller

Adjustment Bolts

c. If the walking belt still slows when walked on, please call our Customer Service Department, toll- free.

14