4.Thread a 1/4” x 1” Bolt (23) with a 1/4” Washer (22) two turns into the upper end of the right Upright (31)
and the right Handrail (32). | Do not tighten the Bolt |
yet. |
|
Thread a 1/4” x 1” Bolt (23) with a 1/4” Washer (22) two turns into the lower end of the right Handrail (32)
and the right Upright (31). Do not tighten the Bolt yet.
5.Set the Console Base (12) on the Handrails (32). Make sure that the Wire Harness (28) is out of the way as you loosely thread four Console Base Screws (91) into the Handrails and the Console Base. Next, push the Wire Harness down the right Upright (31). It may be necessary to pull the Wire Harness out the bottom of the right Upright.
Tighten all parts used in steps 2 and 5. Then, tighten the Console Base Screws (91) used in this step.
6. Attach the Frame Guide (94) and the Frame Guide Spacer (71) to the left side of the Frame (76) with four Screws (48). Note: Be careful not to over- tighten the Screws. Make sure that the thick end of the Frame Guide is at the bottom.
7.Remove the backing from the Wrench Clip (51). Press the Wrench Clip onto the base of the right
Upright (31) in the indicated location. Press the Allen Wrench (90) into the Wrench Clip.
8.Make sure that all parts are tight before you use
the treadmill. | Note: The ratchet screws shown at the | |
right are factory set and | should not be adjusted. | |
Some parts may be left over after assembly is com- pleted. To protect the floor or carpet from damage, place a mat under the treadmill.
7
4 |
|
|
|
| 23 |
32 |
| 22 |
|
| |
|
| 31 |
23 | 22 | |
|
| |
5 |
|
|
28 |
|
|
32 |
|
|
| 91 | 12 |
|
| |
|
| 32 |
|
| 91 |
31 |
|
|
6 |
|
|
76 |
|
|
48 | 71 |
|
94 |
| |
7 |
|
|
|
| 31 |
|
| 90 |
|
| 51 |
8 |
|
|
| Ratchet |
|
| Screws |
|