Diagram of the Console, Battery Installation

DIAGRAM OF THE CONSOLE

	Displays
	On/Reset Button
	Pulse	Sensor
	Clip
Speed Control	Key

CAUTION: Before operating the console, read the following precautions.

•Do not stand on the walking belt when turn- ing on the power.

•Always wear the clip (see the drawing

above) while operating the treadmill. When the key is removed from the console, the walking belt will stop.

•Adjust the speed in small increments.

•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable

water bottle.

BATTERY INSTALLATION

The console requires three "AA" batteries (not includ- ed); alkaline batteries are recommended. Open the

Battery Cover Tab

Battery

Cover

Batteries

battery cover and press the batteries into the console; the negative (–) ends of the batteries must touch the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown in the inset drawing. Be sure that the tab locks into place.

STEP BY STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 8.) In addition, make sure that batteries are installed in the console. If there is a thin sheet of clear plastic on the console, remove it.

Step onto the foot rails of the treadmill. Next, find the clip attached to the key (see the drawing above). Slide the clip onto your waistband.

Follow the steps below and on page 10 to operate the console.

1 Insert the key fully into the power switch.

Note: Inserting the key will not turn on the dis- plays. The displays will turn on when the dis- play on/reset button is pressed or when the walking belt is started. If you just installed bat- teries, the displays will already be on.