Locate the Reed Switch 18 and the Magnet 101 on

Locate the Reed Switch (18) and the Magnet (101) on

the left side of the Pulley (78). Tum the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8". If necessary, loosen the 3/4"

Screw (24) and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, and run the treadmill for a few minutes to check for a correct speed reading.

1/8"-_

24 .;

View

I" II

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outletsurge suppressor that meets all of the specificationsdescribed on page 8.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjustment bolts countemlockwise, 1/4 of a tum. When the walking belt is properly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered; Plug in the power cord, in- sert the key and run the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

Rear Roller Adjustment Bolts

c. If the walking belt still slows when walked on, please call our toll-free HELPLINE.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key

	and UNPLUG THE POWER CORD. If the walking	a
	and UNPLUG THE POWER CORD. If the walking
	belt has shifted to the left, use the allen wrench to
	tum the left rear roller bolt clockwise 1/2 of a turn; if
	the walking belt has shifted to the right, turn the
	boltcounterclockwise1/2 of a turn. Be careful not to
	overtighten the walking belt. Plug in the power cord,
	insert the key and run the treadmill for a few minutes.
	Repeat untilthe walking belt is centered.
	b. If the walking belt slips when walked on, first remove	b
	the key and UNPLUG THE POWER CORD. Using	b
	the key and UNPLUG THE POWER CORD. Using
	the allen wrench, turn both rear roller bolts clockwise,
	1/4 of a turn. When the walking belt is correctly tight-
	ened, you should be able to lift each side of the walk-
	ing belt 3 to 4 inches off the walking platform. Be
	careful to keep the walking belt centered. Plug in the
	power cord, insert the key and carefully walk on the
	treadmill for a few minutes. Repeat until the walking
	belt is properly tightened.

PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com CDs and videos are played

SOLUTION: a. With the key inserted in the console, press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, re-insert the key. The treadmill will automat!-

the incline.

")A