Stamina Products 50-0220 owner manual Assembly Instructions

Page 13

ASSEMBLY INSTRUCTIONS

STEP 16

Attach the LEG LIFT(12) to the SEAT FRAME(11) with BUTTON HEAD BOLT(M10x1.5x65mm)(63), WASHERS(M10)(70), and NYLOCK NUT(M10x1.5)(68). Do not over tighten the bolt, as the LEG LIFT(12) must be able to pivot smoothly.

STEP 17

Slide a FOAM PAD(15) onto a PAD TUBE(14) and screw a SECURING CAP(44) into the end of the PAD TUBE(14). Then insert the other end of the PAD TUBE(14) through the hole in the SEAT FRAME(11). Slide another FOAM PAD(15) over the protruding end of the PAD TUBE(14) and screw a SECURING CAP(44) into the end of the PAD TUBE(14). Repeat to assemble the FOAM PADS(15) to one of the adjustment holes in the LEG LIFT(12).

NOTE: The three adjustment holes in the LEG LIFT(12) allow the FOAM PADS(15) to be attached in three different positions. Start with one of the center positions and adjust if necessary. Use the upper position if users are shorter than average. Use the lower position if users are taller than average.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Model# Safety Instructions Table of ContentsCall Us First BioFLEX Before YOU BeginLabel is larger than actual size Equipment Warning & Notice LabelsHardware Identification Chart Assembly Instructions WASHERSM1070. Securely tighten all of the bolts from Step Assembly Instructions Eyelet End Assembly Instructions Lug Assembly Instructions LAT BAR36 Setting UP the AccessoriesConditioning Guidelines WARM-UP and COOL-DOWN Operational Instructions BioFLEX 2200 Resistance ChartWorkout Instructions Training TipsWorkout Instructions Upright Row Standing Triceps Pushdown Side Bend Storage MaintenanceProduct Parts Drawing PART# Part Name QTY Parts ListPart Name QTY Warranty Limited WarrantyPage Page Stamina Products, Inc Box Springfield, MO FAX/MAIL Ordering Form
Top Page Image Contents