Invacare MA85, MA80 manual Connecting the Hose

Page 12

SECTION 2—OPERATION

Connecting the Hose

CAUTION

Ensure that the hose connecting the control unit to the mattress is routed such that it cannot be stepped on, kinked, squeezed or otherwise damaged.

NOTE: For this procedure, refer to FIGURE 2.3.

1.Locate the hose at the foot end of the mattress.

2.Locate the control unit connector on the right side of the control unit.

3.Lift and hold the connector cover up.

4.Push the hose connector (Detail “A”) onto the control connector.

5.Ensure the hose connector is flush with the control unit connector.

Connector

Cover

Control Unit

Connector

Control

Unit

DETAIL “A”

Hose

Connector

Holes

FIGURE 2.3 Connecting the Hose

MA80 Series

12

Part No 1148138

Image 12
Contents MA80 Series Dealer This manual Must be given to the user of the productSpecial Notes Special NotesTable of Contents Register Online at warranty.invacare.com Register Your ProductTypical Product Parameters Electrical ParametersPerformance Parameters Mechanical ParametersEnvironmental Parameters Label Location Installation General GuidelinesContraindications Entrapment May OccurFire Hazard ElectricalSmoking Anesthesia EquipmentInstalling the Mattress Replacement System OperationInstalling the Side Rails Installing the Control Unit Installing the Mattress Replacement SystemConnecting the Hose Connecting the HoseConnecting the Power Cord Connecting the Power CordUsing the Front Panel Power ButtonPulse Button MA80 Alternating Pressure Button MA85Static Button Firm/Soft ButtonsFowler Button Lock/Alarm Silence Button Power Fail LEDMax Inflate Button Low Pressure LEDPowering Up the System Placing the Patient on the MattressPreparing for CPR Procedure Transferring Patient From/To a GurneyTransferring Patient From/To a Wheelchair Preparing for CPR Procedure Maintenance and Troubleshooting Cleaning the SystemStoring the System Troubleshooting Changing the FilterLimited Warranty USA