Invacare MA80, MA85 manual Connecting the Power Cord

Page 13

SECTION 2—OPERATION

Connecting the Power Cord

WARNING

DO NOT alter plug to fit a non-conforming outlet. Instead, have an electrician install a properly grounded outlet. Failure to use the correct plug and outlet can result in a potential safety hazard.

CAUTION

Ensure that the power cord of the control unit is not pinched, or has any objects placed on it, and also ensure it is not located where it can be stepped on or tripped over.

NOTE: For this procedure, refer to FIGURE 2.4.

1.Examine the hospital grade power cord supplied with the control unit.

2.Perform one of the following:

•If the plug is damaged - Call your supplier for a replacement hospital grade cord.

•If the plug is not damaged - Plug the end of the supplied hospital grade power cord into the power outlet on the side of the control unit.

3.Plug the other end of the plug into a properly grounded outlet on the wall.

NOTE: Once the unit is plugged in, an AMBER LED on the control unit is lit indicating that the system is in STAND BY mode.

Control Unit

Power Outlet

FIGURE 2.4 Connecting the Power Cord

Part No 1148138

13

MA80 Series

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Dealer This manual Must be given to the user of the product MA80 SeriesSpecial Notes Special NotesTable of Contents Register Your Product Register Online at warranty.invacare.comElectrical Parameters Typical Product ParametersPerformance Parameters Mechanical ParametersEnvironmental Parameters Label Location General Guidelines InstallationContraindications Entrapment May OccurElectrical Fire HazardSmoking Anesthesia EquipmentOperation Installing the Mattress Replacement SystemInstalling the Mattress Replacement System Installing the Side Rails Installing the Control UnitConnecting the Hose Connecting the HoseConnecting the Power Cord Connecting the Power CordPower Button Using the Front PanelAlternating Pressure Button MA85 Pulse Button MA80Firm/Soft Buttons Static ButtonFowler Button Power Fail LED Lock/Alarm Silence ButtonMax Inflate Button Low Pressure LEDPlacing the Patient on the Mattress Powering Up the SystemTransferring Patient From/To a Gurney Preparing for CPR ProcedureTransferring Patient From/To a Wheelchair Preparing for CPR Procedure Cleaning the System Maintenance and TroubleshootingStoring the System Changing the Filter TroubleshootingUSA Limited Warranty
Top Page Image Contents