True Fitness manual 99 600/700/725/750 Parts List Diagnostics

3-17 99 600/700/725/750 Parts List Diagnostics 3-18

Bubble No.	600 Part No.	700 Part No.	725 Part No.	750 Part No.	Description	Qty
1	70264600	70233500	70233500	70233702	Pedestal Assembly	1
2	70164600	70164600	70164600	70219500	Pedestal Wire Harness	1
2		70162500	70162500	70175000	HRC Pedestal Wire Harness	1
3	70165502	70163500	70163500	70165100	HandlebarAssy	1
4	70265000	70242300	70242300	70242500	Control Panel, Non	1
4	70265002	70242301	70242301	70242501	Control Panel, P	1
4		70242302	70242302	70242600	Control Panel, HRC	1
5	70182800	70182800	70182800	70182800	Safety Switch, Non Removable	1
9	70155900	70207800	70207800	70207800	Pedestal Screws	6
9	70157000	70190000	70190000	70190000	Star Washer	6
12	70178901	70246503	70246503	70246503	Reading Rack, Non	1
12	70246501	70246504	70246504	70246504	Reading Rack, P	1
12		70246505	70246505		Reading Rack, HRC	1
12		70104000	70104000	70104000	Reading Rack Screws	3
13	70104000	70210600	70210600	70210600	Handlebar Screws	4
14	70162101	70162105	70162104	70171800	Straddle Cover, RT	1
15	70162101	70162105	70162104	70171800	Straddle Cover, LT	1
16	70232700	70183400	70183400	70183400	Bumper-Flex Deck	4,6
16	70086700	70086700	70086700	70086700	Bumper Screws	12
17	70157900	70158000	70159100	70169400	Deck	1
18	70255400	70164700	70164700	70168000	Front Roller	1
19	70157400	70186000	70186000	70168300	Rear Roller	1
20	70159400	70214300	70214400	70214500	Treadbelt	1
21	70155101	70119600	70119600	70172000	Drive Motor	1
22	70043100	70155300	70155300	70146500	Drive Motor Pulley	1
23	70006300	70127600	70127600	70127600	Drive Belt	1
24		70208700	70208700	70208700	Front Roller Screw	2
25	70125600	70125600	70125600	70158900	Carriage Bolt	2
26	70158900	70188600	70188600	70170800	Rear Roller Bolt	2
27	70020200	70020200	70020200	70020200	Deck Screws	6
28	70113200	70171500	70171500	70171500	Incline Actuator	1
29	70121100	70121100	70121100	70173800	Incline RiserAssy	1
31	70154600	70154600	70154600	70154600	Incline Bearing Block	2
32	70126200	70126200	70126200	70126200	Flanged Incline Bearing	2
33	70118900	70118900	70118900	70118900	Swivel Pin	2
34	70176701	70176701	70176701	70173900	Front Wheel	2
35	70243200	70243201	70243201	70243201	Speed Sensor	1
36	70121000	70121000	70121000	70121000	Lower Limit Switch	1
37	70183200	70183200	70183200	70183200	Incline Capacitor	1
38	70219200	70219200	70219200	70183500	PWM Motor Controller	1
39	70251100	70251100	70251100	70251100	On/Off Switch	1
40	70017200	70017200	70017200	70017200	Circuit Breaker	1
41	70253100	70214600	70214600	70214600	Power Cord	1
42	70008200	70008200	70008200	70008200	Strain Relief Bushing	1
43	70120500	70120500	70120500	70120500	Wire-PWM to lower limit switch	1
45	70174300	70174300	70174300	70174300	Front Wheel Bolt	2
46	70115500	70115500	70115500	70115500	Clevis Pin	1
47	70116700	70116700	70116700	70116700	Cotter Pin	1
48	70022600	70022600	70022600	70022600	Set Screw, Incline	2
49		70185400	70185400	70185400	HR Receiver	1
50		70138500	70138500	70138500	HR Chest Strap	1
51	70167000	70167000	70167000	70167000	Autowaxer	1
52	70155200	70155200	70155200	70155200	Rear Bumper Feet	2
53	70020200	70020200	70020200	70020200	Bumper Foot Screws	4
54	70239800	70239800	70239800	70239800	Autowaxer Channel	I

YOUR TRUE TREADMILL IS EQUIPPED WITH BUILT IN

DIAGNOSTIC INFORMATION AND MAINTENANCE REMINDERS

The following error messages will be displayed as they occur. Every time these messages are displayed, a beep will sound twice.

E1:INCLINE	Incline moving when not commanded to.
E1:MINIMUM	Minimum incline calibrating error. Error cleared by calibrating
	incline.
E1:RANGE	Difference between zero position and maximum incline not sufficient.
E1:STALL	Incline not moving when commanded to.
E2:OVERSPEED	This error occurs when an acceleration >2.1 mph occurs.
E2:CAL	Feedback cannot reduce or increase speed to target.
	Error cleared by calibrating.
E3:EEPROM	This error occurs when a data error is detected on the
	EEprom. Replace the control panel.
E5:SENSOR	This message is displayed when there is no speed feedback.

The following service messages will be displayed as they occur, as well as for the subsequent six safety key insertions. These messages will be displayed until a key is pressed. Every time these messages are displayed, a beep will sound twice.

S1:LUBE	This message is displayed when inspection of deck lubrication
	system is recommended.
S2:CLEAN	This message is displayed every 500 miles. - Prompt to clean
	treadmill.
S3:MOTOR	This message is displayed every 2500 hours. - Prompt to check
	motor brushes.