Star Trac E-TBT manual Install the Upper Body Arms

Page 12

M4 x 0.7

Remove the (2) M4 x 0.7 screws from the display back (retain for later use) with a #2 Phillips screwdriver and separate the back of the display from the front. .

M6 x 50mm

Washers

Slide the back of the display with the mounting bracket onto the upper neck of the

Total Body Trainer. Line up all four holes and secure with (4) M6 x 50mm Socket

Head Cap Screws and (4) M6 Washers. Tighten down with the 5mm hex key.

Tighten to 240 lb-in (27 N-m).

Plug in the 12 pin display cable from the neck into the front display circut board at J4. Next plug in the Heart Rate cable from the handlebars into the HR board, then plug the HR ground into the quick disconnect tab on the diplay frame.

NOTE: If you are installing Entertainment, Refer to the PVS Install guide before this step.

If you are not installing Entertainment, take Coax and DC power and return them down the neck.

Slide the bottom of the front display under the 2 tabs at the base the the mount. Press display against the round bar and rotate it to the back. Be careful not to pinch any wires.

 

J4

Ground

Heart

Quick

Wire

Rate

Disconnect

 

 

Board

Tab

 

 

 

M4 x 0.7

M4 x 0.7

Secure the Front display to the back with (8) M4 x 0.7 x 19mm long Phillips Head

Screws. DO NOT overtighten.

3. Install the Upper Body Arms

HUB

Locate left side upper body arm, move to left side of the Total Bodt Trainer. Locate hub. NOTE: One of the holes on the hub has no threads, this is clocking hole for the pin on the upper body arm.

UPPER BODY

ARM

12

STAR TRAC E SERIES TOTAL BODY TRAINERS OWNERS MANUAL

Image 12
Contents Star Trac FitnessTM Table of Contents TBT Total Body Trainer Introduction About this ManualSafety Instructions PrecautionsDo Not Veiligheidsinstructies WaarschuwingConsignes DE Sécurité Mise EN GardeSicherheitsvorschriften WarnungInstruzioni DI Sicurezza AttenzioneInstruções DE Segurança AdvertênciaInstrucciones DE Seguridad AdvertenciaSikkerhedsinstruktioner RådAdvarsler This page Intentioally Blank Assembly and Setup Unpacking and AssemblyTools Required Install the Upper Body Arms Display Panel Features Operating InstructionsPage Selectfit Panel Features Soft Trac SystemHints and Tips for Getting Started Viewing Workout Data During a ProgramPause Mode Using the Personal FANUsing Selectfit Cooldown CycleHeart Rate Monitoring Quick StartContact Heart Rate Monitoring Chest Strap Heart Rate MonitoringPreset Programs Manual ProgramTo operate the Manual program Total Body Program To operate the Total Body programAuto Pilot Program Random Hill / Alpine Pass ProgramsTo operate the Auto Pilot program To operate the Random Hill or Alpine Pass programTraining Tools Programs Heart Rate Control ProgramsTo operate the Dynamic Heart Rate Control program Heart Rate Training Range Upper LevelTo operate the Constant Heart Rate Control program Constant Watts Program To operate the Constant Watts programPreventative Maintenance Daily MaintenanceWeekly Maintenance Monthly MaintenanceManager / Maintenance Mode Manager ModeMaintenance Mode PB-UB Troubleshooting Service MessagesRegulatory Information FCC and Other Domestic RegulationsCanadian DOC and Other Regulations European ApplicationsPage Star Trac
Related manuals
Manual 30 pages 53.79 Kb