Troubleshooting, START-UP Service Messages

TROUBLESHOOTING

STAR TRAC S SERIES TREADMILLS perform a self-test at the beginning of every workout. If a problem is detected, a message displays before or after the workout, depending on the nature of the problem. Star Trac recommends that you refer your questions about your STAR TRAC S SERIES TREADMILL operation and suspected malfunctions to Star Trac’s Service Hotline at (800) 503-1221, or USA 1-714-669-1660.

START-UP SERVICE MESSAGES

The following messages are displayed at the beginning of a workout if the associated problem is detected during self-test.

NO STOP - This error generally occurs when the Stop Switch is not connected tightly to the circuit board of the Display Control Panel. It may also happen if the circuitry associated with the switch develops a fault. When you see NO STOP:

∙Set the ON/OFF switch to OFF; wait 2 seconds.

∙Set the ON/OFF switch to ON. Notify Star Trac if additional assistance is needed.

KEY DOWN - This error generally occurs when a key is held pressed while the ON/OFF switch is moved to ON. It may also happen if a key becomes stuck. When you see KEY DOWN:

∙Set the ON/OFF switch to OFF; wait 2 seconds.

∙Set the ON/OFF switch to ON. The treadmill should be operational again. Notify Star Trac if additional assistance is needed.

SPEED CHANGE: This error generally occur when the running belt speed sensor is disconnected, faulty, or misaligned relative to the revolutions-per-minute (RPM) sensor of the motor. It may also occur if the speed sensor cable is damaged, or if the Motor Control Board (MCB) is misadjusted or faulty. When you see SPEED CHANGE:

∙Set the ON/OFF switch to OFF; wait 2 seconds.

∙Set the ON/OFF switch to ON. Notify Star Trac if additional assistance is needed.

ELEVATION STALL, ELEVATION RANGE OR ELEVATION LOST: These errors generally occur when the elevation (incline) potentiometer is faulty or out of limits, or the elevation motor is disconnected or receiving low power. They may also occur if the Motor Control Board (MCB) is faulty or the motor gears are stripped. They are usually accompanied by failure of the treadmill to rise from an elevation other than maximum (or descend from an elevation other than minimum), with attendant beep indication, when (or ) is pressed. When you see ELEVATION STALL, ELEVATION RANGE OR ELEVATION LOST:

∙Notify Star Trac for diagnosis and disposition.

STAR TRAC S SERIES TREADMILLS OWNER’S MANUAL