Star Trac E-TCI, NOT FOUND manual Display Control Panel Features

Page 33

DISPLAY CONTROL PANEL FEATURES

Your TreadClimber is equipped to provide you and your users unlimited exercise opportunities. Experiment with its features to find the right combination for your fitness regimen. The Display panel shown on the following provides the operating controls and display elements described in the following:

QUICK START Key: Starts your TreadClimber moving using a default weight of 155 lbs / 70 kg and a time limit of 99 minutes. QUICK START will allow you to manually operate the unit. The QUICK START key also serves as an “Enter” key in programming modes.

STOP Key: Pauses your workout when pressed once. Ends your workout when pressed twice.

Graphic Display: Traces your progress through each of the programs and allows you to anticipate changes in terrain. Display elements illuminate from left to right across the bottom of the display to indicate your progress through the course. At each step, display elements illuminate in columns to indicate your ascent up the gradient that is in effect.

Speed Keys: During Program setup, press the

or

keys, respectively, until the desired

speed appears in the Information Window, then, press START or

key. During a Program, press

the

or

keys, respectively, to increase or decrease belt speed in 0.1 miles per hour (mph)

or 0.1 kilometers per hour (km/h) increments. Speed cannot be higher than the established “MAXIMUM SPEED” parameter. These keys repeat when pressed and held.

Speed Window: Shows the speed at which the user is walking/running.

Incline Level Keys: Adjust the amount of up and down movement of the treadles from 1 (minimum) to 5 (Maximum). These keys repeat when pressed and held.

Incline Level Window: Shows the incline level from 1 to 5.

Numeric Keypad: Allow you to enter specific values for program parameters during program setup. The numeric keypad can also be used to adjust TreadClimber® speed while the TreadClimber is operating.

OK Key: Selects/Enters values and programs during set-up.

Time Window: Shows the total time you have walked so far.

Distance Window: Shows the total number of miles or kilometers you have walked thus far.

TREADCLIMBER by STAR TRAC - OWNER’S MANUAL Operating Instructions 33

Image 33
Contents TreadClimber Page Table Of Contents Customer Support ManufacturerImportant Safety Instructions Safety InstructionsStop of Action Alternating Current OFF Do notPage Waarschuwing VeiligheidsinstructiesDOE DIT WEL DOE DIT NietPage Arrêt Mise Hors Service Courant Alternatif Ouvre Ferme Mesures DE PrecautionSicherheitsvorschriften WarnungBedienung Unterbrechen Wechselstrom EIN AUS SIE Sollten SIE Sollten NiemalsLesen SIE Alle Anweisungen VOR DER Benutzung DEL Laufbandes Attenzione Istruzioni DI SicurezzaFerma IL Movimento Corrente Alternata Acceso Spento Leggete Tutte LE Istruzioni Prima DI Usare IL TreadclimberDafare DA NON FareStartrac Advertência Instruções DE SegurançaPare a Ação Corrente Alternada Ligar Desligar Leia Todas AS Instruções Antes DE Usar SUA EsteiraPage Advertencia Instrucciones DE SeguridadParar EL Functionamiento Corriente Alterna ApagadoPage Skal SikkerhedsinstruktionerMÅ Ikke Stop AF Funktion Vekselstrøm Tænd SlukPage Unpacking & Parts List Assembly & SetupAssembly Instructions Final Torque In-Lbs 4.0 Nm Final Torque Final Torque Page Page Page Page Page Operating Instructions Display Control Panel Features Mets Pull Cord Stop HOT BAR Control FeaturesHints and Tips for Getting Started To operate the Quick Start program Quick StartDistance Preset ProgramsHeartRateTraining Programs Using the Cooling Fan Cooldown CycleHeart Rate Monitoring Contact Heart Rate Monitoring Manager Mode Settings & TestingLanguage Maintenance ModeMC1 V WeightLCB V Serial noLast Error Test ErrorMode CCB V USB V Lockout IDMotor Calibration Troubleshooting FCC and Other Domestic / International Regulations Regulatory InformationEFT ESDDaily Maintenance MaintenanceWeekly Maintenance Monthly MaintenanceAdjustments Corporate Headquarters