PYLE Audio PCTL49820 user manual Bolt yet, 39Do. not tighten the Crossbar Screws yet

3. With the help of a second person, raise an Upright (73)			3
to the vertical position.
				42
Identify the Right Handrail (72), which has a large hole				Large
in the left side. Feed the Wire Harness (42) up into the						Bracket
				Hole
bracket on the Right Handrail and out of the large hole in
							63
the left side. Note: It may be helpful to use needlenose
pliers to pull the Wire Harness out of the large hole.						76
Insert the bracket on the Right Handrail (72) into the top				72
of the Upright (73). Attach the Right Handrail with a 1”						73
Bolt (63) and a Flat Washer (76).		Do not tighten the
Bolt yet.
4. Attach the Storage Latch (36) and the Latch Spacer (107)			4
to the Left Handrail (71) with two 1” Latch Screws (112).
Remove the Latch Knob (30) from the Latch Pin (35).				30
Make sure that the Latch Pin Collar (33) and the Spring						112
(32) are on the Latch Pin as shown. Insert the Latch Pin
into the Storage Latch (36) and tighten the Latch Knob						33
back onto the Latch Pin.				107
Attach the Left Handrail (71) to the Upright (not shown)					36	32
				71		35
as described in step 3.
5. Set the Crossbar (40) on the brackets on the Handrails			5
(71, 72). Attach the Crossbar with two Crossbar Screws
(39)Do. not tighten the Crossbar Screws yet.
Attach the end of the ground wire to the small hole in the			71	Bracket
						Ground
side of the Right Handrail (72) with a Silver Ground							77
Screw (77).						Wire
6. Place the Console Base (47) on the Right Handrail (72)				39
				40
and the Left Handrail (not shown). Attach the Console
Base with six 3/4” Screws (2) (two Screws are shown).			Do		Bracket		39
not overtighten the Screws.
					72
Insert the Wire Harness (42) through the two indicated
plastic ties on the Console Base (47). Next,		touch the
Right Handrail (72) to discharge any static.		See the	6	47
inset drawing. Find the 3-wire connector on the end of the
Wire Harness (42). Insert the connector into the red socket				42
beneath the console.	The connector should slide easily
into the socket and snap into place.		If the connector
does not slide easily and snap into place, turn the connec-
tor and then insert it. Insert the 5-wire connector into the
black socket beneath the console in the same way.				Ties	43
Make sure that the connectors and wires appear as			2	56
shown at the right.	IF THE CONNECTORS ARE NOT
INSERTED PROPERLY, THE CONSOLE MAY BE			72		42
DAMAGED WHEN THE POWER IS TURNED ON.
If you plan to use iFIT.com CDs or videocassettes, or pro-					3-wire		5-wire
grams from our Web site (see page 13), plug the Audio
							56
Cable (56) into the jack on the back of the Console (43).
			6