7. Insert the excess Wire Harness (42) into the large hole in
the side of the Right Handrail (72). | Securely tighten the |
plastic ties on the bottom of the Console Base (47) to | |
prevent the Wire Harness from slipping. | Then, cut off |
the ends of the plastic ties. |
|
Route the Wire Harness (42) through the indicated open-
ing in the C onsole Base (47). If you connected the Audio Cable (56) in step 5, route it through the slot in the Wire Cover (44). Attach the Wire Cover to the Console Base
with a 1/2” Silver Screw (49).
8.Attach a Wheel (66) to the inner side of the Base (69) with a Wheel Bolt (64) and a Wheel Nut (109) as shown.
Do not overtighten the Wheel Nut. | The Wheel should |
be able to spin freely. |
|
Attach a Wheel (66) to the other side of the Base (69) in the same way.
9.Lower the Handrails (71, 72) to the floor. Align the Right Handrail (72) with the indicated hole in the Base (69).
Finger tighten a 3 1/2” Bolt (61) with a 5/16” Washer (48) into the Base and the Right Handrail. Attach the Left
Handrail (71) in the same way. | Make sure that the |
Frame (86) is centered between the | Handrails. Firmly |
tighten the 3 1/2” Bolts (61) and the 2 1/2” Bolts (37).
See step 3. | Firmly tighten the 1” Bolts (63). | Then, |
raise the Handrails (71, 72). |
| |
7 |
|
|
| 47 |
|
| Ties | 42 | Opening |
| |
|
|
| |||
|
|
|
|
| |
|
|
|
| 44 |
|
72 |
|
|
|
|
|
|
| 56 | 49 |
|
|
8 |
|
|
|
|
|
| 109 |
|
| 69 |
|
|
|
|
|
| |
| 66 |
|
| 64 |
|
9 |
|
|
|
|
|
86 |
|
|
|
| 69 |
|
|
|
|
| 37 |
|
|
| 71 |
|
|
|
|
| 37 | 48 | 61 |
72 |
|
| 48 |
|
|
69 |
| 61 |
|
| |
|
|
|
|
10. Make sure that all parts are properly tightened before you use the treadmill.Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.
7