Keys Fitness Keys 9000OB, Keys 9000LI owner manual Belt Adjustment

Page 26

Belt Adjustment

WARNING! Do not over-tighten rollers! This will cause prema- ture roller bearing failure!

Belt adjustment and tension performs two functions: adjustment for tension and centering. Your new treadmill comes pre-adjusted from the factory for tension and centering. Please follow the procedures below if the belt shifts to the left or right while walking: WALKING BELT IS SHIFTING TO THE LEFT (Diagram 1) First, turn treadmill on to run at 1 mph. Using the hex key provid- ed, turn the left rear roller adjustment bolt ¼ turn in the clockwise direction. Next, run the treadmill at 2.5 mph. You should see the belt start to correct itself by moving back toward the center. Repeat the above procedure until the walking belt is centered. It may be neces- sary to set walking belt tension once you have completed this proce- dure if the belt feels like it is slipping while walking. Refer below to the “Walking Belt Slipping” instructions.

WALKING BELT IS SHIFTING TO THE RIGHT (Diagram 2) First, turn the treadmill on to run at 1 mph. Using the hex key pro- vided, turn the right rear roller adjustment bolt ¼ turn in the clock- wise direction. Next, run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back toward the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to the “Walking Belt Slipping” instructions.

WALKING BELT IS SLIPPING DURING USE (Diagram 3) First, unplug the power cord from the surge protector. Using the hex key provided, turn both left and right rear roller adjustment bolts the same distance, usually a ¼ turn, in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should now walk on the belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not slipping. The tension should be just tight enough not to slip.

Note: Turning the hex key counter clockwise brings the rear rollers and belt towards you.

Turning the hex key clockwise pushes the rear roller and belt away from you.

26

Diagram 1

Diagram 2

Diagram 3

Image 26
Contents Keys 9000LI Keys 9000OB Table of Contents Important Safety Information Safety Precautions and TipsBefore You Start Assembly Main Components Key #Remove packing material before starting treadmill Assembly Power Requirements Console Panel Functions Keys 9000 Overlay Adjust Weight Press Enter Mode Press Start Program OperationProgram Mode Speed Incline Enter Mode Press StartNext UP/DOWN Press Start User Program Hill Interval Program Speed Incline Level MPH MAX Heart Rate Mode Heart Rate ModeApproaching Target Enter Mode Next UP/DOWN Press StartNext Mode Press Start Beginning Target HR Hands FreeAdjust Weight Enter Mode Press Start Next UP/DOWN Enter Mode Press StartAdjmxgrade + Next Mode Press Start Enter ModeAdjrest + Next Mode Press Start AT Target Workint RestintMonitoring Your Heart Rate Monitoring Your Heart RateTarget Heart Rate Zone Warm Up Exercises Exercise GuidelinesChange to MPH or KPH Calibration Sequence Belt Adjustment Maintenance Instructions To Apply Lubricant to the Walking BoardError Messages Treadmill Error MessagesTroubleshooting Guide Treadmill will not startExploded View Parts List REF# Keys PART# DescriptionWarranty Information Keys Fitness PRODUCTS, LP Limited WarrantyDistribution Drive Suite Garland, TX