NordicTrack NATL81205.0 manual Wheel Bolts the Wheels should turn freely

2.Attach four Base Pads (99) to the base of the Uprights (69) with four 1” Screws (148). Note: One replacement Base Pad may be included. Use the Base Pad to replace any Base Pad that becomes worn.

With the help of a second person, carefully tip the treadmill down so the four Base Pads (99) and the Frame (not shown) are flat on the floor and the Uprights (69) are in a vertical position.

3.With the help of a second person, carefully tip the Uprights (69) down to the floor as shown.

Orient one of the Wheels (95) as shown, and insert it into one of the Wheel Endcaps (101). Next, press the Wheel Endcap and the Wheel into the base of the Uprights (69). Attach the Wheel Endcap and the Wheel with two Wheel Bolts (94) and two Nuts (9). Do not overtighten the

Wheel Bolts; the Wheels should turn freely.

Attach the other Wheel (95) and Wheel Endcap (101) as described above.

With the help of a second person, carefully raise the Uprights (69) to the vertical position.

4.Cut the tie securing the Pulse Wire (66) to the Uprights (69). Hold the Pulse Bar Assembly (65) near the crossbar on the Uprights. Connect the Pulse Wire to the wire in the Pulse Bar Assembly. The connectors should slide to- gether easily and snap into place. If they do not, turn one connector and try again. Insert the wires into the crossbar.

Attach the Pulse Bar Assembly (65) to the crossbar on the Uprights (69) with four Pulse Bar Bolts (33) and four Star Washers (77). Start all four Pulse Bar Bolts and then tighten them. Make sure that no wires are pinched.

2		69
	148
		99
		148
	148
		99
		148
3		95
			94
	69
		101
95		9
101
94
		9
4
		33
		77
		69	33
		77
		66
		65
	66

7