ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key and your own phillips screwdriver , rubber
mallet and adjustable wrench . For help identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 34 and 35. The number following the parentheses is the quantity needed for assembly.
Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra hard- ware may be included.
| 5/16” Star | 3/8” Star | Extension Leg |
Nut | Washer | Nut | |
|
| Washer | |
3/4” Screw | 1” Tek Screw |
| Base Cover Screw |
|
|
| |
Console Bolt | Latch Bolt |
| Extension Leg Bolt |
1.Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the treadmill onto its side as shown. Partially fold the Frame (55) so that the treadmill is more sta- ble. Do not fully fold the Frame until the treadmill is completely assembled.
Insert an Extension Leg (97) into the indicated bracket on the base of the Uprights (85). Make sure that the Extension Leg is turned so the Base Pad (81) is on the side shown. If necessary, use a rubber mallet to align the holes in the Extension Leg with the holes in the bracket.
Attach the Extension Leg (97) with two Extension Leg Bolts (87), two 5/16" Star Washers (110), and two Extension Leg Nuts (91) as shown.
Firmly tighten the Extension Leg Bolts.
1 |
|
| Bracket |
| 85 |
87 | 110 |
| |
| 91 |
| 97 |
| 81 |
55 |
|
7 |
|