NordicTrack NTL77806.0 user manual

Page 8

5.With the help of a second person, set the con- sole assembly on the Uprights (85). Make sure that no wires are pinched. Attach the console assembly with four Console Bolts (72) and four Star Washers (67). Start all four Console Bolts before tightening any of them.

6.Press the Latch Insert (77) into the right side of the left Upright (85), and press the Knob Insert (92) into the left side of the left Upright. Use a rubber mallet, if necessary.

Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Next, in- sert the pin into the Latch Insert, and tighten the knob back onto the pin.

5

Console

 

 

Assembly

67

67

72

72

85

85

6

 

Knob

77

92Spring

Collar

85

Pin

7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet from damage, place a mat under the treadmill.

If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the re- ceiver included with the chest pulse sensor.

1.Make sure that the power cord is unplugged. Remove the indicated Screw (7) and the Access Door (95) from the left side of the Console Base (98).

2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base

(98). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (95) with the two included small screws.

3.Make sure that no wires are pinched. Reattach the Access Door (95) with the Screw

(7). Discard the other wires included with the re- ceiver.

98

Wire

 

 

Small

 

Screws

95

 

 

A

 

Small

7

Cylinder

8

 

Image 8
Contents Call TOLL-FREE QUESTIONS?Model No. NTL77806.0 Serial No Table of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unpluggedDo not fully fold the treadmill until it is com Pletely assembledAgain. if the Connectors are not CON Page PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeYour heart rate accurately. Before using Make sure that your hands are cleanTraining Zones 18. Note For simplicity, all instructionsTurn on the fan if desired Whenkey. you are finished exercising, removeHOW to USE a Preset Program Select one of the preset programsSelect one of the custom programs HOW to Create a Custom ProgramFollow your progress with the displays HOW to USE a Custom Program HOW to USE AN Ifit Card Insert an iFIT Card and select a programUSER’S Mode HOW to Adjust the Cushioning System Optional Chest Pulse SensorHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useTop View Problem The walking belt slows when walked on Page Conditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0606A Qty DescriptionOrdering Replacement Parts Exploded DRAWING-Model No. NTL77806.0 Part 2 Part 3 Part 4 Limited Warranty