Assembly

Handrail Bolt (90)–4

3/4” Tek Screw

Panel Screw

Console Bolt (110)–4

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own Phillips screwdriver . For help identifying the assembly hardware, see the hardware drawings below.

HandrailBracket Bolt(31)–4

UprightBolt (113)–4

Washer (116)–4	Star Washer
	(114)–4

1.Raise the end of the Frame (not shown) until the tread- mill can be moved on the Front Wheels (66), and care- fully roll the treadmill off the wood pallet.

Insert the Wire Harness (108) through the Upright Plate

With the help of a second person, hold the Upright (111) and the Upright Plate (115) against the Frame Cover

(52).See the inset drawing and make sure that the Upright is oriented at the angle shown and that the Upright Plate is oriented as shown. Attach the Upright and the Upright Plate with four Upright Bolts

(113)with two Star Washers (114). Make sure that the

Upright Bolts are inserted straight into the Upright and the Frame Cover. Do not tighten the Upright Bolts yet.

1	115
	115
	111
	111
	66
	108
	114
	52
	115
	114
	113