NordicTrack NTL12950 guide

8.Set the console assembly on the Upright Base (85). Make sure that no wires are pinched. Finger tighten a Console Bolt (72) with a Star Washer (67) into the lower hole in each side of the Upright Base (only one side is shown).

Next, finger tighten a Short Console Bolt (112) with a Star Washer (67) into the upper hole in each side of the Upright Base (85) (only one side is shown). Be careful not to drop the Short Console Bolts into the Upright Base. Do not tighten the Short Console Bolts yet.

9.Slide the two Upright Covers (75) onto the ends of the Handrails (68, 70). Set the Handrails (68, 70) on the Console Front (98). Make sure that the posts on the

Handrails are set in the holes in the Console Front. Insert a Console Bolt (72) into the bottom of the right Upright Base (85) and loosely thread the Upright Bolt into the post on the Right Handrail (70). Repeat with the Left Handrail (68).

Align the holes in the lower ends of the Handrails (68, 70) with the holes in the Upright Base (85). Do not cut the in- dicated tie.

Loosely thread four Handrail Bolts (66) with four Star Washers (67) into the Handrails (68, 70) and the Upright Base (85). Start all four Handrail Bolts but do not tighten them yet.

10.Firmly tighten the Console Bolts (72) and the Short Console Bolt (112). Firmly tighten the four Handrail Bolts (66) (see step 9).

Press the Upright Cover (75) onto the right Upright Base (85). Attach the Upright Cover with a 3/4” Screw (7).

Insert an Upright Endcap (71) into the top of the right Upright Base (85). Note: Insert the end of the Upright Endcap indicated by the arrow first; use a rubber mallet if necessary.

Repeat this step on the other side (not shown).

8
	85
	67
	112
	67			Console
				Console
	72			Assembly
	72
9	Post
	Post
	68
75		72	98
75
			Post
			Post
			70	72
	67
66		85	75	Do Not
				Cut
				85
				67
			66
10
		112
	71
		72
				70
		85		75
				75
		7