ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench and your own phillips screwdriver and
wire cutters . For help identifying the assembly hardware, see the hardware drawings below.
Star Washer | 3/4” Tek Screw | 1” Tek Screw |
| Short Console | |
|
| Bolt |
Extension Screw | 3/4” Screw | Handrail Bolt |
|
| |
Console Bolt | Pulse Bar Bolt |
1.Open parts bag A. With the help of a second person, carefully raise the Upright Base (85) and the Frame (55) to the position shown.
While the other person holds the Frame (55) and the Upright Base (85), insert the Base Extension (90) into the two brackets on the lower end of the Upright Base. Make sure that the Base Extension is turned so the Base Pads (81) are beneath it. Note: It may be helpful to tip the Upright Base forward as you insert the Base Extension.
1 |
|
|
|
| 55 |
|
| Brackets |
81 | 90 | 85 |
| ||
| 81 | |
|
|
6