MTD 190-182,190-180 Attaching Bracket Assembly, Attaching The Bracket Assembly, Model Series

3

Attaching

Bracket

Assembly

Model Series 600

IMPORTANT:

Before assembly,

place the tractor on a firm, level surface, disengage the PTO, stop the tractor engine and set the parking brake.

NOTE:

There are two holes

in the clevis pin. Be sure to insert the hairpin clip in the upper hole to properly secure the bracket assembly to the hitch plate.

Attaching The Bracket

Assembly

Model Series 600

IMPORTANT: Before assembly, place the tractor on a firm, level surface, disengage the PTO, stop the tractor engine and set the parking brake.

1. For convenience, pivot the seat forward and leave it in that position until the grass collector is fully mounted and assembled.

2. Position the hooked ends of the bracket assembly over the shoulder bolts (1). Swing in the bottom of

the bracket assembly down and in (2) over the hitch

plate and aligning with the hole on the hitch plate. Hitch Plate See Fig. 3-1.

3.Insert the clevis pin (B1 in Fig. 2-2) through the aligned holes in both the bracket assembly and the hitch plate and secure with the hairpin clip (B2 in Fig. 2-2). Refer to Figure 3-2.

NOTE: There are two holes in the clevis pin. Be sure to insert the hairpin clip in the upper hole to properly secure the bracket assembly to the hitch plate.

Figure 3-1

Upper Hole

Figure 3-2