2.Insert two 4 1/2" Bolts (96) with Handrail Washers (95) into the right Upright (83). Next, lift the right Handrail (73) slightly and align the Handrail Bolts with the holes in the Handrail. Thread the Handrail Bolts into the Handrail. Do not tighten the Handrail Bolts yet. Be careful not to pinch the wires.
Attach the left Handrail (not shown) in the same way. Make sure that the Handrail Washers (95) are flush against the Uprights (83), with the thick sides facing the center of the treadmill, as shown in the inset drawing. Then, tighten all four
Handrail Bolts (96).
3.With the help of a second person, carefully tip both Uprights (83) to the floor.
Insert the three Cage Nuts (28) into the three in- dicated holes in the treadmill.
To insert each Cage Nut (28), first hook one side of the Cage Nut into a hole and then use a flat- bladed screwdriver to press the other side into the hole, as shown.
2 |
|
| |
|
| 83 | |
|
| 95 | |
| 83 | Thick | |
| 95 | ||
73 | Side | ||
| |||
|
| ||
| 95 | 96 | |
|
| ||
3 |
|
|
83
28
28
4.With the help of a second person, carefully raise the Upright (83) to a vertical position. Press the Lock Knob Sleeve (87) into the right side of the left Upright, and press the Lock Knob Spacer (86) into the other side of the left Upright.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (If there are two collars, make sure that there is one on each side of the spring.) Next, insert the pin into the Lock Knob Sleeve (87) and the left Upright (83). Then, tighten the knob back onto the pin.
4 |
|
|
Knob | 83 |
|
| 86 |
|
|
| Spring |
| 87 | Pin |
|
| Collar |
7 |
|
|