Assembly

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials, unless otherwise instructed. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included hex key and your own flat-bladed screwdriver , wire cut-

ters , and adjustable wrench .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the treadmill or the shipping carton. This is a normal con- dition and does not affect treadmill performance. If there is lubricant on top of the walking belt or foot pads, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Cage Nut (28)–3	Handrail Washer	2" Bolt (114)–3
		2" Bolt (114)–3

	(95)–4

4 1/2" Bolt (96)–4
1. With the help of a second person, carefully raise	1
both Uprights (83) to a vertical position. Remove	1
both Uprights (83) to a vertical position. Remove
any packaging from the crossbar.
Remove the elastic holding the Upright Wire		120
Remove the elastic holding the Upright Wire
Harness (131) in the right Upright (83). Have a
second person hold the Handrails (73) near the
Uprights. Connect the Upright Wire Harness to		131
the wires extending from the Console Base
(120). Make sure to connect the connectors
properly (see the inset drawing). The connec-	73	83
tors should slide together easily and snap		83


into place. If they do not, turn one connector
and try again. IF THE CONNECTORS ARE NOT		Crossbar
CONNECTED PROPERLY, THE CONSOLE		Crossbar
CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS
TURNED ON.
Insert the connectors and the Upright Wire
Harness (131) into the hole in the right Upright
(83). Then, set the Handrails (73) on the		131
Uprights, being careful not to pinch the wires.		131
Uprights, being careful not to pinch the wires.

ASSEMBLY

and try again. IF THE CONNECTORS ARE NOT