NordicTrack NTL21905.0 user manual Left side Treadmill

Page 8

2.Insert the Right Upright (74) into the indicated bracket on the Base (83); be careful not to dislodge the Cage

Nuts (76 [see the inset drawing]) from the Right Upright; in addition, be careful not to pinch the Upright Wire Harness (75). Finger tighten three Upright Bolts (72) with three Washers (78) and three Upright Star Washers (71) into the bracket and the Right Upright. Do not tighten the Upright Bolts yet.

Repeat this step with the Left Upright (73).

3.Attach the Catch (5) to the left side of the Frame (48) with two 3/4” Screws (4).

4.With the help of a second person, raise the Frame (48) to a vertical position. Be careful not to raise the Frame past the vertical position. Have the other person hold the Frame until step 5 is completed.

Identify the Gas Spring (88). Note that the Gas Spring has a cylinder end and a piston end. See the small inset drawings. Locate the Spring Pin (102) in the cylinder end of the Gas Spring. Using your fingernail or the end of a screwdriver, press on the end of the Spring Pin, rotate the Spring Pin, and then pull the Spring Pin out of the Gas Spring. Do not lose the Spring Pin. Note: Extra Spring Pins are included in the literature bag.

Next, hold the cylinder end of the Gas Spring (88) near the indicated bracket beneath the Frame (48). Press the end of the Gas Spring as far as possible onto the ball on the bracket. See the large inset drawing. Insert the Spring Pin (102) into the indicated small holes in the end of the Gas Spring, and rotate the Spring Pin until it clips onto the Gas Spring.

8

2

73

75

 

 

 

 

74

 

 

 

 

 

78

72

 

 

 

71

 

 

 

78

 

 

 

76

72

 

 

 

 

 

 

 

 

 

83

 

 

 

71

Bracket

 

 

 

 

 

3

 

 

 

 

Left side of

Treadmill

4

5

48

 

4

 

Piston

 

Cylinder

 

88

102

 

Bracket

48

 

102

 

 

102

 

88

102

 

Hole

Bracket

 

 

Hole

Image 8
Contents Call TOLL-FREE QUESTIONS?Model No. NTL21905.0 Serial No Table of Contents Important Precautions Page Power Lines Right Side Before YOU BeginBack Assembly Left side Treadmill Page Page HOW to Connect AN Antenna HOW to Connect a 75 OHM Catv CableHOW to Connect a VCR Indoor AntennaHOW to USE the Chest Pulse Sensor HOW to PUT on the Chest Pulse SensorChest Pulse Sensor Troubleshooting Chest Pulse Sensor Care and MaintenancePRE-LUBRICATED Walking Belt HOW to Plug in the Power CordTreadmill Operation Features of the Console HOW to Turn on the Power HOW to Personalize Console SettingsSelect the users mode Select the settings modePage HOW to USE the Manual Mode Whenkey. you are finished exercising, remove Measure your heart rate if desiredTurn on the fans if desired Press the Start button to start the program HOW to USE a Cardio ProgramSelect a Cardio program HOW to USE a Calorie Program Select a Calorie programHOW to USE a Distance Program Press the start button and adjust the speedHOW to Create a Record Program Select a Distance programHOW to USE a Record Program Turn on the fan if desiredSelect a Pulse program HOW to USE a Pulse ProgramAdjust the maximum target heart rate setting if Desired Turn on the fans if desired HOW to USE AN Ifit Card Insert an iFIT Card and select a programHOW to Operate the Personal Television HOW to USE the TV Settings ModeHOW to Adjust the Cushioning System HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useTop Gap between the Magnet and the Reed Switch isProblem The walking belt slows when walked on Problem Television reception is poor Problem The chest pulse sensor does not function properlyExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0306A Qty DescriptionHOW to Order Replacement Parts Exploded DRAWING-Model No. NTL21905.0 119 113 112 115 114 118 110 100 102 109 Limited Warranty