Horizon Fitness DT850, DT650 manual E a S S E M B LY, Open Hardware BAG

INTRODUCTION IMPORTANT PRECAUTIONS

P R E - A S S E M B LY

DO NOT CUT STRAPS UNTIL STEP 1-E!* Disassemble box and remove the

WARNING cardboard packaging that is not beneath the treadmill. Do not attempt to lift the

treadmill at this time. Remove plastic wrap from console masts.

note: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.

A S S E M B LY STEP 1

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

HARDWARE BAG 1 CONTENTS :

#0-5
" 
NN 2UZ


-&'5
$0/40-&
."45

#0-5
"

-&'5
4*%&
-*/,"(&
"3.

AOpen HARDWARE BAG 1.

BLift left console mast into upright position. Be sure to hold the console mast firmly, as it will not stay in the upright position on it’s own.

CMove left side linkage arm into position. Insert bolt (A) and tighten.

DRepeat on the right side.

ENow cut the banding straps and remove remaining packaging material.*

CONDITIONING GUIDELINES

*Note: If the straps have been removed before completing step 1-D and the linkage arms can not be aligned, refer to the troubleshooting section (page 26) in order to restore the treadmill to its proper position.

TROUBLESHOOTING LIMITED & MAINTENANCE WARRANTY

7







FLift the running deck until lock latch on side of treadmill is fully engaged.

GRemove console from box and place out of the way.

HLower the treadmill running deck from the folded position by stepping on LOCK LATCH on lower right side.