INTRODUCTION IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING TROUBLESHOOTING LIMITED
GUIDELINES & MAINTENANCE WARRANTY
10
A S S E M B LY STEP 3
HARDWARE BAG 3 CONTENTS : |
|
|
|
BOLT (G) | SPRING WASHER (H) | FLAT WASHER (I) | ARC WASHER (J) |
15 mm | 15 mm | 19 mm | 17 mm |
Qty: 4 | Qty: 4 | Qty: 2 | Qty: 2 |
| CONSOLE CABLES | |
CONSOLE |
| |
ARC WASHER (J) | DO NOT ATTACH | |
THIS SIDE UNTIL STEP | ||
| ||
| CONSOLE MAST | |
| FLAT WASHER (I) | |
| SPRING WASHER (H) | |
| BOLT (G) |
AOpen HARDWARE BAG 3.
BWith running deck in lowered position, place console on the console masts. Align the brackets that are underneath the console with the top holes of the console masts.
CTo assemble the CONSOLE to the LEFT CONSOLE MAST, insert 1 BOLT (G), 1 SPRING WASHER (H) and 1 FLAT WASHER (I) into the side hole and insert 1 BOLT (G), 1 SPRING WASHER (H) and 1 ARC WASHER (J) into the back hole in the left CONSOLE mast and lightly tighten.
DGently lift right side of the console to connect the console cableS. Carefully tuck wires in mast to avoid damage. NOTE: Do not pinch console cable or grip pulse wires.
ERepeat step C above to assemble the right console mast to the console.
FLeave console bolts loose until after step 4 is completed.
A S S E M B LY STEP 4
HARDWARE BAG 4 CONTENTS :
BOLT (K) 15 mm Qty: 4
CONSOLE MAST |
SUPPORT BAR |
BOLT (K) |
A.Open Hardware Bag 4.
B.Align SUPPORT BAR with holes in CONSOLE MASTS.
C.Insert BOLTS (K) into all 4 holes of the SUPPORT BAR.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
D.Tighten all console bolts (Step 3) and support bar bolts (Step 4) completely.
11
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
T83_Treadmill_Rev.1.8.indd | 7/9/07 9:56:07 AM |