HOW TO USE CUSTOM PROGRAMS
1 Insert the key fully into the console.
See HOW TO TURN ON THE POWER on page 12.
2 Select custom program 1 or 2.
When the key is inserted, the manual mode will be selected. To select a custom program, press the MODE button re- peatedly until the custom 1 or 2 indicator lights.
Press the START button or the SPEED + but-
3 ton to start the program.
A moment after the button is pressed, the walking belt will begin to move. Hold the handrails and begin walking.
Each custom program is di-
vided into one-
minute peri- ods. One speed setting and one in- cline setting
are pro- grammed for
each period.
The speed setting for the first period is shown in the flashing CURRENT PERIOD column of the LED matrix. (The incline settings are not shown in the matrix.)
When only three seconds remain in the first period of the program, both the CURRENT PERIOD col- umn and the column to the right will flash and a
series of tones will sound. All speed settings will then move one column to the left. The speed set- ting for the second period will then be shown in the CURRENT PERIOD column and the speed and incline of the treadmill will adjust to the sec- ond settings that you programmed previously.
The program will continue in this way until the speed setting for the last period is shown in the CURRENT PERIOD column and the TIME display counts down to zero. The walking belt will then slow to a stop.
During the program, the speed and incline settings for the current period can be adjusted with the SPEED and INCLINE buttons. Adjustments will not be saved in memory. To reprogram speed and incline settings, press the LEARN button. The LEARN indicator will light. Speed and incline set- tings can be reprogrammed only when the in- dicator is lit. Next, adjust the speed and incline of the treadmill with the SPEED and INCLINE but- tons. When the current period of the program is completed, the new speed and incline settings will be saved in memory. When you have repro- grammed speed and incline settings for as many periods as desired, press the LEARN button again.
To stop the program temporarily, press the STOP button. The TIME display will begin to flash. To restart the program, press the START button or the SPEED + button. To end the program, press the STOP button, remove the key, and then rein- sert the key.
4 Follow your progress with the LED displays.
See step 5 on page 13.
5 Whenkey. the program is completed, remove the
See step 6 on page 13.
17