JVC CA-FSP5 manual Recording on a Tape, Check the recording direction for the tape, Press REC

Page 19

Recording

Continued

IMPORTANT:

It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable programme and in any literary, dramatic, musical, or artistic embodied therein.

The recording level is automatically set correctly, so it is not affected by the VOLUME, AHB (Active Hyper Bass) PRO, and SOUND MODE settings. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

You can use type I tape for recording.

To protect your recording

Cassettes have two small tabs on the back to protect from unexpected erasure or re-recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape.

To keep the best recording and playback sound quality

If the heads, capstans, and pinch rollers of the cassette decks become dirty, the following will occur:

Impaired sound quality

Discontinuous sound

Fading

Incomplete erasure

Difficulty in recording

To clean the heads, capstans, and pinch rollers

Use a cotton swab moistened with alcohol.

Capstans

Heads

Pinch rollers

To demagnetize the heads

Turn off the unit, and use a head demagnetizer (available at electronics and audio shops).

At the start and end of cassette tapes

There is leader tape which cannot be recorded onto. Thus, when recording CDs or radio broadcasts, wind the leader tape first to ensure that the recording will be made without any music part lost.

Recording on a Tape

On the unit ONLY:

1 Put a recordable cassette in with the exposed part of the tape down.

2 Close the cassette holder gently.

If you want to record on both sides of a tape, see “To record on both sides — Reverse Mode.”

3 Check the recording direction for the tape.

If the tape direction is not correct, press TAPE 2 3 twice then 7to change the tape direction.

4 Start playing the source — FM, AM or auxiliary equipment connected to AUX jacks.

When the source is CD, see “CD Direct Recording” on page 17.

5 Press REC.

REC

 

The REC indicator lights up on the display and recording starts.

The REC lamp on the unit also lights red.

REC

To stop recording, press 7.

To remove the cassette, press 0 for cassette deck.

To record on both sides — Reverse Mode

Press REV.MODE on the unit until the

REV.MODE

 

indicator is lit.

 

When using the reverse mode for recording, start recording in the forward (3) direction first. Otherwise, recording will stop when recording is done only on one side (reverse) of the tape.

– 16 –

Image 19
Contents Compact Component System Mises en garde, précautions et indications diverses Instructions for safe use Introduction PrecautionsAbout This Manual Contents Become familiar with the buttons and controls on your unit Location of the Buttons and ControlsFront Panel Front PanelFront Panel Display Window Display WindowRemote Control Remote ControlGetting Started Supplied Accessories Connecting AntennasAM antenna Connecting SpeakersTurn the AM loop antenna until you have the best reception Release the finger from the clampTo connect audio equipment Connecting Other EquipmentBy using audio cords not supplied, connect To remove the speaker grillesSelecting the Sources and Starting Play Turning On the PowerSetting the Clock Common OperationsSelecting the Sound Modes Adjusting the VolumeSelecting the Display Brightness Reinforcing the Bass SoundListening to FM and AM Broadcasts Tuning in a StationPresetting Stations Tuning in a Preset StationPress CD 3/8 Playing Back CDs CD/CD-R/CD-RWPlaying Back the Entire CD Normal Play Basic CD OperationsRepeat to program other tracks you On the remote control only Load a CDProgram Play Press Prog programOn the unit only Playing at Random Random PlayProhibiting Disc Ejection Tray Lock Repeating Tracks Repeat PlayPress 0for cassette deck To play both sides Reverse ModePlaying Back Tapes Playing Back a TapePress REC RecordingRecording on a Tape Check the recording direction for the tapeTo stop CD Direct Recording, press 7. The tape stops after CD Direct RecordingOne Track Recording Repeat steps 2 and 3 to record other tracks you wantUsing Daily Timer and Recording Timer Using the TimersWait for about 5 seconds after specifying the time length Using Sleep TimerOn the remote control only Press Sleep How Sleep Timer actually worksSymptom TroubleshootingHandling cassette tapes MaintenanceCleaning the unit Handling discsSpecifications Authorized Service Centers Limited Warranty 0401MWMMDWJEM