JVC SP-UXP5, CA-FSP5 manual Program Play, On the remote control only Load a CD, Press Prog program

Page 16

Programming the Playing Order of the Tracks

— Program Play

You can arrange the order in which tracks play before you start playing. You can program up to 20 tracks.

To check the program contents

You can check the program contents by pressing PROG on the remote control. The programed tracks are shown in the programed order.

PROG

On the remote control ONLY:

1 Load a CD.

• If the current playing source is not the CD player, press

To modify the program

Before or after playing, you can erase the last programed track by pressing CANCEL on the remote control.

CANCEL

CD 3/8, then 7 before going to the next step.

2 Press PROG (program).	PROG

The PRGM (program) indicator lights up on the display.

PRGM

•If a program has been stored in memory, the program is called up.

3 Press MULTI KEY > or MULTI KEY < to select the track number, then press SET.

MULTI KEY

SET

		PRGM

		Track number Program step number
4	Repeat step 3 to program other tracks you
5	want.
5	Press CD 3/8.		CD

The tracks are played in the order you have programed.

To stop playing, press 7.

To exit from Program play mode, press 7before or after playing. The PRGM (program) indicator goes off. All the programed tracks will be cleared.

• Disc ejection also erases the program.

•Each time you press the button, the last programed track is erased from the program.

To add tracks in the program before playing, simply select the track numbers you want to add by following step 3 of the programming procedure.

•If you try to program the 21st track “FULL” will appear on the display.

•If the total playing time is 100 minutes or more

The total playing time will not be shown. “– –:– –” will appear.

– 13 –

Image 16

Contents Compact Component System Mises en garde, précautions et indications diverses Instructions for safe use Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Become familiar with the buttons and controls on your unitDisplay Window Front Panel Display WindowRemote Control Remote ControlSupplied Accessories Connecting Antennas Getting StartedConnecting Speakers Turn the AM loop antenna until you have the best receptionRelease the finger from the clamp AM antennaConnecting Other Equipment By using audio cords not supplied, connectTo remove the speaker grilles To connect audio equipmentTurning On the Power Setting the ClockCommon Operations Selecting the Sources and Starting PlayAdjusting the Volume Selecting the Display BrightnessReinforcing the Bass Sound Selecting the Sound ModesTuning in a Station Presetting StationsTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back CDs CD/CD-R/CD-RW Playing Back the Entire CD Normal PlayBasic CD Operations Press CD 3/8On the remote control only Load a CD Program PlayPress Prog program Repeat to program other tracks youPlaying at Random Random Play Prohibiting Disc Ejection Tray LockRepeating Tracks Repeat Play On the unit onlyTo play both sides Reverse Mode Playing Back TapesPlaying Back a Tape Press 0for cassette deckRecording Recording on a TapeCheck the recording direction for the tape Press RECCD Direct Recording One Track RecordingRepeat steps 2 and 3 to record other tracks you want To stop CD Direct Recording, press 7. The tape stops afterUsing the Timers Using Daily Timer and Recording TimerUsing Sleep Timer On the remote control only Press SleepHow Sleep Timer actually works Wait for about 5 seconds after specifying the time lengthTroubleshooting SymptomMaintenance Cleaning the unitHandling discs Handling cassette tapesSpecifications Authorized Service Centers Limited Warranty 0401MWMMDWJEM