Listening to FM and AM Broadcasts
Tuning in a Station |
| 3 Repeat steps 1 and 2 to store stations for the | |
|
| other band. | |
1 Press FM/AM. |
| ||
FM/AM | |||
The unit automatically turns on and tunes in | |||
|
| ||
the previously tuned station (either FM or |
| When you cannot automatically store stations you want | |
AM). |
| Stations with weak signals cannot be detected with this automatic | |
• Each time you press the button, the band |
| presetting. To store such a station, use the manual presetting. | |
alternates between FM and AM. |
|
| |
2 Press and hold ¢or 4 for more than 1 second.
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the ST (stereo) indicator lights up.
To stop searching, press ¢or 4.
When you press ¢or 4 briefly and repeatedly
The frequency changes step by step.
To preset stations manually — Manual Presetting
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.
On the remote control ONLY:
1 Tune in the station you want to preset.
• See “Tuning in a Station.”
2 Press SET.
SET
To change the FM reception mode
When an FM stereo broadcast is hard to receive or FM MODE noisy, press FM MODE on the remote control so 
that the MONO indicator lights up on the display.
Reception improves.
To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In this stereo mode, you can hear stereo sounds when a program is broadcasted.
Presetting Stations
You can preset 30 FM and 15 AM stations — using either automatic presetting or manual presetting.
In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.
To preset stations automatically
— Automatic Presetting
You need to preset stations separately for the FM and AM bands.
On the remote control ONLY:
1 | Press FM/AM to select the band. | FM/AM |
| ||
| • Each time you press the button, the band |
|
| alternates between FM and AM. |
|
2 | Press and hold AUTO PRESET for | AUTO |
PRESET |
more than 2 seconds.
Local stations with strong signals are searched and stored in memory automatically.
When automatic presetting is over, the station stored in preset number 1 is received.
3 Press MULTI KEY > or
MULTI KEY < to select a preset | MULTI KEY |
| |
number. |
|
4 Press SET again.
SET
The tuned station in step 1 is stored in the preset number selected in step 3.
•Storing a new station on a used number erases the previously stored one.
When you unplug the AC power cord or if a power failure occurs
The preset stations will be erased in a few days. If this happens, preset the stations again.
Tuning in a Preset Station
On the remote control ONLY:
1 Press FM/AM. | FM/AM |
|
The unit automatically turns on and tunes in the previously tuned station (either FM or AM).
•Each time you press the button, the band alternates between FM and AM.
2 Press MULTI KEY > or
MULTI KEY < to select a preset | MULTI KEY |
| |
number. |
|
– 11 –