JVC SP-UXP5, CA-FSP5 manual Maintenance, Handling discs, Cleaning the unit, Handling cassette tapes

Page 24

Maintenance

To get the best performance of the unit, keep your discs, tapes, and mechanism clean.

Handling discs

• Remove the disc from its case by holding it at the edge while pressing the center hole lightly.

• Do not touch the shiny surface of the disc, or bend the disc.

• Put the disc back in its case after use to prevent warping.

• Be careful not to scratch the surface of the disc when placing it back in its case.

• Avoid exposure to direct sunlight, temperature extremes, and moisture.

To clean the disc

Wipe the disc with a soft cloth in a straight line from center to edge.

Cleaning the unit

•Stains on the unit

Should be wiped off with a soft cloth. If the unit is heavily stained, wipe it with a cloth soaked in water-diluted neutral detergent and wrung well, then wipe clean with a dry cloth.

•Since the unit may deteriorate in quality, become damaged or get its paint peeled off, be careful about the followings.

—DO NOT wipe it with a hard cloth.

—DO NOT wipe it strong.

—DO NOT wipe it with thinner or benzine.

—DO NOT apply any volatile substance such as insecticides to it.

—DO NOT allow any rubber or plastic to remain in contact with it for a long time.

DO NOT use any solvent — such as conventional record cleaner, spray, thinner, or benzine — to clean the disc.

Handling cassette tapes

• If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating.

•If the tape is loose, it may get stretched, cut, or caught in the cassette.

•Be careful not to touch the tape surface.

•Avoid the following places to store the tape:

— In dusty places

— In direct sunlight or heat

— In moist areas

—On a TV or speaker

—Near a magnet

– 21 –

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Compact Component System Mises en garde, précautions et indications diverses Instructions for safe use Precautions IntroductionAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Become familiar with the buttons and controls on your unitDisplay Window Front Panel Display WindowRemote Control Remote ControlSupplied Accessories Connecting Antennas Getting StartedConnecting Speakers Turn the AM loop antenna until you have the best receptionRelease the finger from the clamp AM antennaConnecting Other Equipment By using audio cords not supplied, connectTo remove the speaker grilles To connect audio equipmentTurning On the Power Setting the ClockCommon Operations Selecting the Sources and Starting PlayAdjusting the Volume Selecting the Display BrightnessReinforcing the Bass Sound Selecting the Sound ModesTuning in a Station Presetting StationsTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back CDs CD/CD-R/CD-RW Playing Back the Entire CD Normal PlayBasic CD Operations Press CD 3/8On the remote control only Load a CD Program PlayPress Prog program Repeat to program other tracks youPlaying at Random Random Play Prohibiting Disc Ejection Tray LockRepeating Tracks Repeat Play On the unit onlyTo play both sides Reverse Mode Playing Back TapesPlaying Back a Tape Press 0for cassette deckRecording Recording on a TapeCheck the recording direction for the tape Press RECCD Direct Recording One Track RecordingRepeat steps 2 and 3 to record other tracks you want To stop CD Direct Recording, press 7. The tape stops afterUsing the Timers Using Daily Timer and Recording TimerUsing Sleep Timer On the remote control only Press SleepHow Sleep Timer actually works Wait for about 5 seconds after specifying the time lengthTroubleshooting SymptomMaintenance Cleaning the unitHandling discs Handling cassette tapesSpecifications Authorized Service Centers Limited Warranty 0401MWMMDWJEM
Top Page Image Contents