Thermador WD30, WD27 Cleaning and Maintenance, Removing the Drawer, Replacing the Drawer, Part

Cleaning and Maintenance

Cleaning

Part	Recommendations
Drawer interior (polished	Use dish detergent.
stainless steel)	Wash, rinse well and dry.
	For hard water spots or
	scale, use white vinegar.
	Apply with a sponge or
	cloth, rinse, and dry.
	Heat Discoloration/
	Corrosion: Clean with
	Bar Keeper‘s Friend®
	sprinkled on a wet
	sponge or wet cloth and
	applied to the wet
	stainless steel surface.
	Rub gently and evenly in
	the direction of the grain.
	Rinse and dry.
Painted surfaces	Use hot soapy water or
	mild cleaners such as
	Fantastik or Formula
	409Wash, rinse well
	and dry. Avoid using
	abrasive cleaning
	agents, steel wool pads
	and oven cleaners.
Drawer exterior frame	Always wipe or rub in the
(brushed stainless steel)	direction of the grain.
	Clean with a soapy
	sponge, then rinse and
	dry, or wipe with
	Fantastik® or Formula
	409® sprayed on a
	paper towel. Protect and
	polish with Stainless
	Steel Magic® and a soft
	cloth. Remove water
	spots with a cloth
	dampened with white
	vinegar.
Warming Drawer Control	Clean with hot soapy
	water or apply
	Fantastik® or Formula
	409® to a clean sponge
	or paper towel and wipe
	clean. Avoid using
	abrasive cleaners and
	scrubbing pads.

Maintenance

Removing the Drawer

WARNING:

To prevent burns, do not remove drawer while hot. Be sure drawer is empty before removing.

1.Pull drawer to fully open position.

2.Press down right drawer clip.

3.Lift up left drawer clip.

4.Firmly pull the drawer straight out. Retract cabinet rails while drawer is removed.

Replacing the Drawer

1.Be sure cabinet rails are pushed inside cabinet.

2.Align the drawer rails with the cabinet rails.

3.Firmly push the drawer straight into the cabinet until drawer clicks into place.

4.Open and close drawer to test operation. Note: if the drawer will not close, verify that the rail clips are properly positioned.

English 6